Furinno NT-13015 User manual

Assembly Instruction
Customer Service
Tel/Fax: [phone]
Toll Free: 773.299.8111 (Mon - Fri 9am - 5pm)
Email: [email protected]
WARNING:
>This unit has been designed to support the
maximum loads shown. Exceeding these
load limits could cause sagging, instability,
product collapse, and/or serious injury.
>DO NOT allow children to climb on unit.
>Put heavier items on lower shelves.
its Space. its Budget
www.furinno.com
Slot in Panel(K)to Panel(H)(I)&(J).
Attach Plastic Drawer Front Panel(8)to
Panel(H)&(I).
STEP 8
Attach Panel(H)&(I)to Panel(J).
Repeat the same method as Step 3.
STEP 7
Recommended Maximum Weight
Furinno Ubah No Tools Entertainment
Center w/2-Drawers
NT1301520140425
MODEL : NT-13015
46.3”(W) x 15”(H) x 15.6”(D)DIMENSION :
40
*Unit in Pound(lbs)
Upright the unit.
Slide in 2 sets of drawer to the unit.
Insert Runner Stopper(5)to the
pre-drilled hole of Panel(H)&(I),
STEP 9
Tool RequiredTool RequiredNo Tools Required
Recomm. 1 PersonRecomm. 2 Person
Approx. 5 minutesApprox. 10 minutesApprox. 15 minutesApprox. 30 minutesApprox. 40 minutes

STEP 5
5.1 Face down the unit and attach Panel(L).
5.2 Insert Corner Pin(7)into the pre-drilled
holes of Panel(L).
Insert Plastic Pin(6)into pre-drilled holes
of Panel(L).
STEP 6
STEP 3
Attach Panel(C)&(D)to Panel(E).Turn on
Cam-Lock and fix into the pre-drilled nut.
Turn off Cam-Lock when the panel were fixed.
Attach Panel(F)&(G)to Panel(E)with Dowel(1,2).
Attach Panel(A)&(B)to assembled unit.
Repeat the same method as Step 3.
STEP 4
STEP 1
1.1 Fix Small Lock Switch(4)into the Cam-Lock
of Panels(C)(D)&(E).
1.2 Fix Large Lock Switch(3)into the Cam-Lock
of Panels(F)(G)(H)(I)&(J).
Insert Short Plastic Dowel(1)to Panel(C)(D)
and Shelf Bar(E).
STEP 2
turn on turn off
finished edge
finished
edge
finished
edge
USEFUL HINTS BEFORE YOU START:
1. Read each step carefully before starting.
2. It is important that each step is performed in correct order to avoid difficulties.
3. Identify, sort and count the parts before assembly.
4. Assemble your furniture on packaging cardboard to prevent scratch or damage.
5. Clean the product with mild cleanser using soft damped cloth. Do not use harsh or abrasive cleanser.
6. Using uncompatible hardware might cause damage to product.
1
2
16pcs
2pcs
A 1pcs
Top Panel
No Hardware List Qty No QtyParts List
Short Plastic Dowel
Long Plastic Dowel B
C
1pcs
1pcs
Left Side Panel
Bottom Panel
D
E
F
1pcs
1pcs
1pcs
Top Center Panel
Right Side Panel
Shelf Bar
G
H
1pcs
2pcs
Drawer Left Side Panel
Bottom Center Panel
I
J
2pcs
2pcs
Drawer Rear Panel
Drawer Right Side Base
K
L
2pcs
1pcs
Back Panel
Drawer Base
3 20pcs
Large Lock Switch
4 12pcs
Small Lock Switch
5 4pcs
Runner Stopper
6
7
8
16pcs
4pcs
2pcs
Plastic Drawer
Front Panel
Plastic Pin
Corner Pin
slot in
(3&4)
(6)x16pcs
(A) (E)
(J)
(B)
(F) (K)
(C)
(I)
(H)
Cam-Lock
(L)
(D)
(E)
(C)
(D)
(1)x12pcs
Arrow Label
(7)x4pcs
(L)