Furniture of America Arthur CM7587D User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM7587D
Assembly Instructions
Tools Required for Assembly:
Page 1 of 4
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED
Allen Wrench (Included)
CM7587M
DRESSER AND MIRROR ARE SOLD AND PACKED SEPARATELY
Rev.15-09 -08

Page 2 of 4

Parts List
#1 x 1 pc
Mirror
#2 x 1 pc
Dresser
#3 x 2 pcs
Mirror Support Bracket
#A x 8 pcs
Bolt 1/4”x1-1/2”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage, especially
with the fragile nature of the mirror.
MD
Page 3 of 4
Hardware List
#D x 1 pc
Allen Wrench
#C x 8 pcs
Lock Washer
#B x 8 pcs
Flat Washer

Page 4 of 4
Turn right (clockwise) to tighten
Adjust the leveler according
to the ground level. To
lower or to raise the center
leg, you need to turn the
leveler clockwise or
counterclockwise,
respectively.
I. The two mirror support brackets (#3) are already attached behind the dresser
(#2). Position the mirror support brackets (#3) vertically to align with the pre-
drilled holes of the dresser (#2) AND the mirror (#1).
II. Prepare 6 bolt assemblies by inserting FIRST the lock washer (#C) onto the bolt
(#A) and then the flat washer (#B) onto the SAME bolt (#A), in that order. The
other 2 bolt assemblies are already attached to the mirror support brackets (#3)
from the factory.
III. Insert the bolt assemblies onto the mirror support brackets (#3) and secure those
bolts using an Allen wrench (#D) to lock the mirror support brackets (#3) with the
dresser (#2)AND the mirror (#1).
IV. Tighten all bolts, including those that were already attached from the factory.
Back Side
Back Side #A x 8 pcs
#B x 8 pcs
#C x 8 pcs
ASSEMBLY IS COMPLETED