Furniture of America Clement CM-BK928TF User manual

Right Ladder Tube
Upper Side Frame
Lower Middle Frame
Lower Side Frame
Upper Middle Frame

Align one lower rail (#5) to the rear support tube (#1) and front
support tube (#2). Insert bolts (#B) into each end and secure
using the Allen wrench (#G).
Align one lower rail (#5) to the rear support tube (#1) and right
ladder tube (#18). Insert bolts (#B) into each end and secure
using the Allen wrench (#G).
Insert the upper end rail (#3) and upper end rail (#4) onto the top of the tubes.

Top Assembly:
Align the 2 upper side frames (#13) to the pre-
drilled holes on the ends and insert bolts (#A)
into each pre-drilled hole. Secure using the
Allen wrench (#G). Then align 2 upper middle
frames (#14) to the pre-drilled holes along the
center and insert bolts (#A) into each hole.
Secure using the Allen wrench (#G).
Bottom Assembly:
Align the 2 lower side frames (#11) to the pre-
drilled holes on the ends and insert bolts (#A)
into each pre-drilled hole. Secure using the
Allen wrench (#G). Then align 2 lower middle
frames (#12) to the pre-drilled holes along the
center and insert bolts (#A) into each hole.
Secure using the Allen wrench (#G).
I. Align the top part of the front guardrail (#6)
and the rear guardrail (#5) to the top pre-
drilled holes on the upper end rails.
II. Insert a bolt (#C) into each end from within.
Secure using the Allen wrench (#G).
I. Align the front guardrail
(#6) to the side you wish
to install the ladder and
the rear guardrail (#5) to
the corners of the upper
end rails.
II. Align a spacer (#F) to
each end and insert
bolts (#E). Secure using
the Allen wrench (#G).
I. Align the rear
connect bar (#7)
and the front
connect bar (#8)
to the bottom pre-
drilled holes along
the sides of the
lower bed rails.
Make sure they
match the upper
rail placements.
II. Align a spacer (#F)
to each end and insert
bolts (#E). Secure using
the Allen wrench (#G).

Align the bottom connect bar (#10)
to the center pre-drilled holes located
under the bed frames. Then insert 2
bolts (#I) into the holes along the
center. Secure using the Allen wrench
(#G). Insert a bolt (#B) into each end
and secure using the Allen wrench (#G).
I. Align the ladder cross-bars (#16) to the pre-drilled holes along the side of
the right ladder tube (#18). Insert 3 bolts (#H) and secure using the Allen
wrench (#G). Then align the ladder rail (#15) to the other ends of the cross-
bars and insert 3 more bolts (#H). Secure using the Allen wrench (#G).
II. Insert a bolt (#C) to the top and bottom hole on the ladder rail (#15).
Secure using the Allen wrench (#G).

Align the top of the support legs (#17) to the bottom of the lower
middle frame. Insert 2 bolts (#A) into each from the top and
secure using the Allen wrench (#G).
Make sure all parts are firmly secured.
ASSEMBLY IS COMPLETED