Furniture of America Frontier CM3603BN User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM3603BN
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-09-10
Page 1 of 4
DIFFICULT
ASSEMBLY RATING

Page 2 of 4

Parts List
#1 x 1 pc
Bench
#2 x 4 pcs
Leg
#A x 8 pcs
Bolt 5/16”x2-1/8”
#B x 8 pcs
Flat Washer
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 8 pcs
Lock Washer
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around
during the assembly. ALWAYS have at least two
people to help with transporting and assembling the
product to avoid any potential injury and/or damage.
MD
Page 3 of 4
#D x 1 pc
Allen Wrench
Hardware List

Page 4 of 4
I. Carefully turn the completed bench upright. Make sure the
bench is rested on a flat surface and does not feel loose or
wobbly. If it does, double check that the bolts/screws are
secured and properly tightened.
II. If needed, adjust the levelers according to the ground level. To
lower or to raise the leg, turn the leveler clockwise or
counterclockwise, respectively.
#A x 8 pcs
#B x 8 pcs
#C x 8 pcs
I. Carefully place the bench
(#1) facing down on a
protected surface.
II. Align the 4 legs (#2) with the
pre-drilled holes on the
corners of the bench (#1).
III. Prepare 8 bolt assemblies
by inserting FIRST the lock
washer (#C) onto the bolt
(#A) and then the flat washer
(#B) onto the SAME bolt
(#A), in that order.
IV. Insert the bolt assemblies
through the pre-drilled holes
on the corners of the bench
(#1) and secure those bolts
using the Allen wrench (#D)
to lock them with the 4 legs
(#2).
Turn right (clockwise) to tighten
ASSEMBLY IS COMPLETED