Furniture of America CM4636S User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM4636S
Allen Wrench (Not Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-06-04
Page 1 of 4
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED

Page 2 of 4

Parts List Hardware List
#1 x 1 pc
Table Top
#2 x 4 pcs
Leg
#3 x 1 pc
Table Base
#A x 1 pc
Allen Wrench
#B x 8 pcs
Bolt 5/16”x2”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 8 pcs
Flat Washer
MD
#D x 8 pcs
Lock Washer
Page 3 of 4
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage.

Page 4 of 4
I. With the help of another person,
carefully place the table top (#1)
facing down on a protective
surface.
II. Align the 4 legs (#2) with the pre-
drilled holes on the bottom of the
table top (#1).
III. Prepare 4 bolt assemblies by
inserting FIRST the lock washer
(#D) onto the bolt (#B) and then
the flat washer (#C) onto the
SAME bolt (#B), in that order.
IV. Insert the bolt assemblies through
the pre-drilled holes of the table
top (#1) and secure those bolts
using theAllen wrench (#A) to lock
them with the legs (#2).
#B x 4 pcs
#C x 4 pcs
#D x 4 pcs
I. Align the table base (#3) with the pre-
drilled holes on the legs (#2).
II. Prepare 4 bolt assemblies by inserting
FIRST the lock washer (#D) onto the bolt
(#B) and then the flat washer (#C) onto the
SAME bolt (#B), in that order.
III. Insert the bolt assemblies through the pre-
drilled holes of the table base (#3) and
secure those bolts using the Allen wrench
(#A) to lock them with the legs (#2).
IV. Carefully place the table in its upright
position. Make sure the table is rested on
a flat surface and it does not feel loose or
wobbly. If it does, double check that the
bolts are secured and properly tighten.
Turn right (clockwise) to tighten
#B x 4 pcs
#C x 4 pcs
#D x 4 pcs
Turn right (clockwise) to tighten
#2
#C
#D
#C
#D
#2
ASSEMBLY IS COMPLETED