Furniture of America CM3130T User manual

Attention:
Please follow instructions on
lighting carefully through
each steps.
1) Prepare 12 bolts assembly by inserting lock washer (#D), then flat washer (#C) onto bolts (#A). Attach wood
dowels (#I) to the holes of leg stand A (#4) and leg stand B (#6) as shown in the diagram.
2) Align leg stand A (#4) and leg stand B (#6) to the holes of leg stand C (#5). Secure with bolts (#A).
3) Align leg stand D (#7) to the holes of leg stand B (#6) and leg stand A (#4). Secure with bolts (#A).
Attach the electrical connectors together from all around the leg stands.
Electrical connectors from leg stand (#6) must be connected to the electrical
connectors of leg stand (#5) and leg stand (#7). Also electrical connectors
from leg stand (#4) must be connected to the electrical connectors of leg
stand (#5) and leg stand (#7).

Prepare 6 bolts assembly by inserting lock washer
(#F), then flat washer (#E) to bolts (#B). Align
table top base (#3) to the holes of the leg stand,
then secure with bolts (#B). Make sure to pull the
electrical connectors through the hole of the table
top base (#3) as shown in the diagram.
Prepare 8 bolts assembly by inserting lock washer (#F), then flat washer (#E) onto bolts (#B). Align table top
base (#3) to the holes of the table top (#1). Make sure the electrical connectors from the table base is near the
battery pack. Secure base with bolts (#B).
Battery Pack

Connect the electrical connectors together.
Separate the table top (#1), then place the leaf (#2) in-between
the extended table top (#1) as shown in the picture.
Touch sensor to activate light.