Furniture of America CM3318PT User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM3318PT
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-03-05
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED

Page 2 of 5

Parts List
#1 x 1 pc
Table Top
#2 x 4 pcs
Leg
#3 x 1 pc
Table Leaf
#A x 8 pcs
Flat Washer 5/16”
#B x 8 pcs
Lock Washer 5/16”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 8 pcs
Bolt 5/16”x2-3/4”
Due to the size and weight of this product, it is highly
recommended that the assembly should be done near the area
of its intended location. Make sure you have enough space to
move around during the assembly. ALWAYS have at least two
people to help with transporting and assembling the product
and to avoid any potential injury and/or damage.
MD
#D x 1 pc
Allen Wrench
Page 3 of 5
Hardware List

Step 1
I. With the help of another person, carefully place the table top (#1)
facing down on a protected surface.
II. Align the leg (#2) with the bottom corner of the table top (#1) as shown
below.
III. Prepare two bolt assemblies by inserting FIRST the lock washer (#B)
onto the bolt (#C) and then the flat washer (#A) onto the SAME bolt
(#C), in that order.
IV. Insert the bolt assemblies through the two pre-drilled holes on the
bottom corner of the table top (#1) and secure those bolts using the
Allen wrench (#D) to lock it in with the leg (#2).
V. Repeat the process for the remaining 3 legs (#2).
Step 2
Turn right (clockwise) to tighten
Page 4 of 5
Enlarged
#A x 8 pcs
#B x 8 pcs
#C x 8 pcs
With the help of another person, carefully turn the
completed table upright. Make sure the table is
rested on a flat surface and it does not feel loose or
wobbly. If it does, double check that the bolts are
secured and properly tighten.

Page 5 of 5
Step 3
#3
I. To remove the table leaf (#3) unlock the 4 tension-lever
locking latches located under the table.
II. Once unlocked, slide outward on both ends of the outer
two-piece table top until there is sufficient opening to
remove the table leaf (#3).
III. After removing the table leaf (#3), slide inward on both
ends of the outer two-piece table top until they are
touching and sitting flush with each other.
IV. Secure the two tension-lever locking latches under the
table to lock both side of the outer two-piece table top.
V. Store the table leaf (#3) in a cool and dry place.
Enlarged
Enlarged
ASSEMBLY IS COMPLETED