Furniture of America CM3603T User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM3603T
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-09-10
Page 1 of 4
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED

Page 2 of 4

Parts List
#1 x 1 pc
Table Top
#2 x 4 pcs
Leg
#A x 8 pcs
Bolt M8x55mm
#B x 8 pcs
Flat Washer
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 8 pcs
Lock Washer
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around
during the assembly. ALWAYS have at least two
people to help with transporting and assembling the
product to avoid any potential injury and/or damage.
MD
Page 3 of 4
#D x 1 pc
Allen Wrench
Hardware List

Page 4 of 4
I. With the help of another person, carefully turn the completed
table upright. Make sure the table is rested on a flat surface and
does not feel loose or wobbly. If it does, double check that the
bolts/screws are secured and properly tightened.
II. If needed, adjust the levelers according to the ground level. To
lower or to raise the leg, turn the leveler clockwise or
counterclockwise, respectively.
#A x 8 pcs
#B x 8 pcs
#C x 8 pcs
I. With the help of another
person, carefully place the
table top (#1) facing down
on a protected surface.
II. Align the 4 legs (#2) with the
pre-drilled holes on the
corners of the table top (#1).
III. Prepare 8 bolt assemblies
by inserting FIRST the lock
washer (#C) onto the bolt
(#A) and then the flat washer
(#B) onto the SAME bolt
(#A), in that order.
IV. Insert the bolt assemblies
through the pre-drilled holes
on the corners of the table
top (#1) and secure those
bolts using the Allen wrench
(#D) to lock them with the 4
legs (#2).
Turn right (clockwise) to tighten
ASSEMBLY IS COMPLETED