Furniture of America CM4229C User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-10-23
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
CM4229C
2 PERSONS RECOMMENDED

Page 2 of 5

#3 x 1 pc
Glass Top
Parts List
#1 x 2 pcs
Long Leg Stand
#2 x 2 pcs
Short Leg Stand
#A x 8 pcs
Bolt 1/4”x1/2”
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
MD
Page 3 of 5
#C x 4 pcs
Leveler
#B x 8 pcs
Lock Washer
#E x 1 pc
Allen Wrench
#D x 6 pcs
Spacer
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly.ALWAYS have at least two people to
help with transporting and assembling of the product
and to avoid any potential injury and/or damage.

Page 4 of 5
#A x 8 pcs
#B x 8 pcs Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
I. Align the 2 short leg stands (#2)
with the brackets of the 2 long
leg stands (#1). Make sure the
screw holes for the levelers (#C)
on the 2 long leg stands (#1) are
facing upward.
II. Prepare 8 bolt assemblies by
inserting the lock washer (#B)
onto the bolt (#A).
III. Insert the bolt assemblies
through the short leg stands (#2)
and secure those bolts using the
Allen wrench (#E) to lock them
with the long leg stands (#1).
#C x 4 pcs
Align the threaded ends of the 4 levelers (#2) with the pre-
drilled holes on the corners of the long leg stands (#1) and
tighten by hand until secured.
Adjust the levelers according to
the ground level on Step 4.

Page 5 of 5
Make sure the table is rested on a flat surface and does not feel loose
or wobbly. If it does, double check that the bolts/screws are secured
and properly tightened. If necessary, adjust the levelers (#C)
according to the ground level. To lower or to raise the levelers (#C),
turn the levelers clockwise or counterclockwise, respectively.
ASSEMBLY IS COMPLETED
#D x 6 pcs
I. Place the assembled leg stands in the upright position.
II. Insert 6 spacers (#D) into the pre-drilled holes of the leg stands.
III. With the help of another person, carefully place the glass top
(#3) on top of the spacers (#D). The glass top (#3) should be
evenly centered and flatly rested.