Furniture of America CM-BK913QQ User manual

Align the upper rear and front tubes (#9,10) to the holes along the upper headboards
(#1,2), then insert the bolts (#F) into each hole. Secure using the Allen wrench (#H).
Align the lower rear and front tubes (#11,12) to the holes along the lower headboards
(#3), then insert the bolts (#F) into each hole. Secure using the Allen wrench (#H).

Insert the connect tubes (#4) into the
slots, then insert the bolts (#A) into each
hole. Secure using the Allen wrench (#H).
Insert the ends of the upper headboards
into the tubes, then insert the bolts (#A)
and secure using the Allen wrench (#H).

1. Align the ladder (#15) to the holes along the tubes, then insert the bolts (#D) into the top ends. Secure.
2. Align the bottom ends, then
insert bolts (#E) and secure.
3. Align the front and back guardrails to the holes, then insert the bolts (#F) and secure.
Align the bed frames (#7,8) to the
holes indicated, then insert the
bolts (#B) into each hole. Secure
using the Allen wrench (#H).

1. Align the middle tubes
to the frames, then insert
the bolts (#C) into the
center holes. Secure using
Allen wrench (#H).
2. Insert the bolts (#B) into each end of the middle tubes and secure.
Align the support tubes (#14)
to the bottom frames, then
insert the bolts (#B) into
the holes from above. Secure
using the Allen wrench (#H).

Separating the bunk beds:

Place the caps (#G).
Align the support tubes to the top bed and secure.
Place the caps (#G)