Furniture of America CM4327S User manual

Remove drawers.
1. Place the table top
(#1) face down onto
a protected surface.
2. Prepare 6 bolt asse-
mblies by first inserting
a lock washer (#B) onto
the bolt (#A) then a
flat washer (#C) onto
that same bolt (#A).
3. Align the legs (#3) to
the corner holes, then
insert 2 bolts into each
corner. Secure using
the Allen wrench (#D).

1. Prepare 3 bolt assemblies by first inserting a
lock washer (#B) onto the bolt (#A) then a
flat washer (#C) onto that same bolt (#A).
2. Align the shelf (#2) to the holes along
the ends of three legs (#3).
1. Prepare 3 bolt assemblies by first
inserting a lock washer (#B) onto
the bolt (#A) then a flat washer
(#C) onto that same bolt (#A).
2. Align the last leg (#3), then insert
the bolts into each holes and secure
using the Allen wrench (#D).
3. Insert the support
leg (#4) into the
center hole and
turn right to tight-
en. Adjust accord-
ing to ground level.

Insert drawers.
1. Drill a hole along the wall
slightly smaller than the
long screw, then align a
bracket to the hole and
insert a long screw, secure.
2. After that align the other
bracket to the back of
the assembly and insert
a small screw. Secure
using a screwdriver.
3. Secure the strap
accordingly.
ASSEMBLY IS COMPLETED