Furniture of America CM-BK601 User manual

AssemblyInstructions
For more information contact our team: [email protected]
Rev.18-07-25

Use cardboard or carpet area when
assembling furniture to prevent
scratches .Make sure the furniture
rests on a flat and level surface with
each leg evenly touching the floor.
No dragging of products/parts.

1. Align the ends of the lower front side
rail (#5) and the lower back side rail (#6)
to the pre-drilled holes along the sides
of the lower end guardrail (#1,2).
3. Insert the bolt (#A) into the pre-
drilled holes along the side and
into the barrel nut (#B). Secure
using the Allen wrench (#I).
2. Insert the barrel nuts (#B)
into the rails, and align the
hole for the bolt.
2. Insert the barrel nuts
(#B) into the 2 bottom
holes along the rails.
Insert 3 bolts (#A) into
the pre-drilled holes
along the outer sides of
(#3,4) and into the barrel
nut (#C). Note, the top
hole does not go into a
nut. Secure bolts using
the Allen wrench (#I).
Do not tighten bolts/screws
until they are all installed.
1. Align the ends of the rails
(#16,17) to the upper end
guard rails (#3,4).

1. Insert a metal dowel
(#E) into the large pre-
drilled holes along the
top corners of the
bottom bunk.
2. With the help of another person,
carefully place the top bunk onto
those metal dowels (#E).
Align the top and bottom of the ladder (#7) to the pre-drilled
holes along the front rails. Insert a bolt (#C) into each end
from within the rails and secure using the Allen wrench (#I).

Apply the twin slat kit
(#9) onto the top bunk.
Insert a screw (#G) into
each end and secure
using a screwdriver.
Apply the full slat kit
(#8) onto the top bunk.
Insert a screw (#G) into
each end and secure
using a screwdriver.
2. Insert a wood dowels (#F)
into the pre-drilled holes
along the corners of the
front panel (#10).
3. Place the right side
(#12) and left side
(#11) onto the other
ends of those wood
dowels (#F).
1. Place the front panel
(#10) face down.
Note: Right and left is determined
by facing the front of the front
panel (#10) in its upright position.
Right
Left

Insert 2 screws (#H) into
the holes along the sides
of (#11/12). Secure using
a Phillips screwdriver.
Align the bottom panel (#14) to the ridges
along the sides and carefully slide in.

Place the back panel (#13) and insert
2 screws (#H) into each end. Secure
using a Phillips screwdriver.
Align the center support (#15) to the
pre-drilled holes along the center
of the front and back panel (#10/13).
Insert a screw (#H) into each end
and secure using a screwdriver.
Repeat process for
second drawer.
#10
#13