Furniture of America CM6833WH User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-10-28
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
CM6833WH
2 PERSONS RECOMMENDED
Phillips Screwdriver (Not included)
CM6833BK

Page 2 of 5

Parts List Hardware List
#1 x 8 pcs
Leg
#2 x 1 pc
Sofa
#3 x 1 pc
Chaise
#A x 8 pcs
Bolt 5/16”x1”
#B x 8 pcs
Flat Washer
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 1 pc
Allen Wrench
MD
#D x 32 pcs
Wood Screw
Page 3 of 5
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly.ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage.

Page 4 of 5
I. Remove the legs (#1) and
hardware from underneath
the sofa (#2).Align the 4
legs (#1) with the pre-drilled
holes on the bottom of the
sofa (#2).
II. Prepare 4 bolt assemblies by
inserting the flat washer (#B)
onto the bolt (#A).
III. Insert the bolt assemblies
through the 4 legs (#1) using
the Allen wrench (#C) to lock
them with the sofa (#2).
IV. Insert 4 wood screws (#D)
through each leg (#1) using
the Phillips screwdriver to
lock them with the sofa (#2).
Turn right (clockwise) to tighten
#A x 4 pcs
#B x 4 pcs
#D x 16 pcs
Turn right (clockwise) to tighten
Repeat Step 1 to assemble the other 4
legs (#1) onto the chaise (#3). The legs
(#1) and hardware are stored
underneath the chaise (#3).
#A x 4 pcs
#B x 4 pcs
#D x 16 pcs

Page 5 of 5
ASSEMBLY IS COMPLETED
I. Connect the sofa (#2) and the chaise (#3) together as shown
below by locking the male brackets with the female brackets.
II. Make sure the unit is rested on a flat surface and does not feel
loose or wobbly. If it does, double check that the bolts/screws are
secured and properly tightened.
#2 #3