Furniture of America CM7979Q User manual

Rev: 16-08-01

190x30x30mm
#G x 1pc
AC Adapter

1. Prepare 6 bolt assemblies by first inserting a lock washer (#C) onto
the bolt (#B) then a flat washer (#D) onto that same bolt (#B).
Note: Left and right is
determined by facing the
front of the headboard
in its upright position.
2. Align the right and left headboard legs (#2,3)
to the holes along the sides of the headboard
(#1), then insert 3 bolt assemblies into each
leg and secure using the Allen wrench (#A).
#G

Carefully hook the ends of each side rail (#5) into the slots
located along the headboard legs (#2,3) and footboard (#4).
1. Prepare 3 bolt assemblies by inserting a lock washer (#C) onto the bolt (#B),
then align the slat support leg (#7) to the holes along the center of the slats (#6)
and insert a bolt assembly from the top. Secure using the Allen wrench (#A).
2. Align the ends of the slats (#6) to
the side rails (#5), then insert a
screw (#E) into each end and secure
using the a Phillips screwdriver.
Adjust the leveler accordingly.
ASSEMBLY IS COMPLETED

Rev: 16-07-15

190x30x30mm

1. Prepare 6 bolt assemblies by first inserting a lock washer (#C) onto
the bolt (#B) then a flat washer (#D) onto that same bolt (#B).
2. Align the right and left headboard legs (#2,3) to the holes along
the sides of the headboard (#1), then insert 3 bolt assemblies
into each leg and secure using the Allen wrench (#A).
Note: Left and right is
determined by facing the
front of the headboard
in its upright position.

Carefully hook the ends of each side rail (#5) into the slots
located along the headboard legs (#2,3) and footboard (#4).
1. Prepare 5 bolt assemblies by inserting a lock washer (#C) onto the bolt (#B),
then align the slat support leg (#7) to the holes along the center of the slats (#6)
and insert a bolt assembly from the top. Secure using the Allen wrench (#A).
2. Align the ends of the slats (#6) to
the side rails (#5), then insert a
screw (#E) into each end and secure
using the a Phillips screwdriver.
Adjust the leveler accordingly.
ASSEMBLY IS COMPLETED

Rev: 16-08-01

190x30x30mm
#G x 1pc
AC Adapter

1. Prepare 6 bolt assemblies by first inserting a lock washer (#C) onto
the bolt (#B) then a flat washer (#D) onto that same bolt (#B).
Note: Left and right is
determined by facing the
front of the headboard
in its upright position.
2. Align the right and left headboard legs (#2,3) to the holes along
the sides of the headboard (#1), then insert 3 bolt assemblies
into each leg and secure using the Allen wrench (#A).
#G

Carefully hook the ends of each side rail (#5) into the slots
located along the headboard legs (#2,3) and footboard (#4).
1. Prepare 5 bolt assemblies by inserting a lock washer (#C) onto the bolt (#B),
then align the slat support leg (#7) to the holes along the center of the slats (#6)
and insert a bolt assembly from the top. Secure using the Allen wrench (#A).
Adjust the leveler
accordingly.
2. Align the ends of the slats (#6) to
the side rails (#5), then insert a
screw (#E) into each end and secure
using the a Phillips screwdriver. ASSEMBLY IS COMPLETED