Furniture of America Edgemont CM3681DK-PT User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
CM3681DK-PT
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-04-04
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
2 PERSONS RECOMMENDED

Page 2 of 5

Parts List
#1 x 1 pc
Table Top
#2 x 1 pc
Table Leaf
#3 x 4 pcs
Leg
#A x 8 pcs
Bolt 5/16”x2-1/4”
#B x 8 pcs
Flat Washer
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
#C x 8 pcs
Lock Washer
Due to the size and/or weight of this product, it is
highly recommended that the assembly should be
done near the area of its intended location. Make
sure you have enough space to move around during
the assembly. ALWAYS have at least two people to
help with transporting and assembling the product to
avoid any potential injury and/or damage.
MD
#D x 1 pc
Allen Wrench
Page 3 of 5
Hardware List

I. With the help of another
person, carefully place the
table top (#1) facing down on
a protected surface.
II. Align the legs (#3) with the
bottom corners of the table top
(#1).
III. Prepare 8 bolt assemblies by
inserting FIRST the lock
washer (#B) onto the bolt (#A)
and then the flat washer (#C)
onto the SAME bolt (#A), in
that order.
IV. Insert the bolt assemblies
through the pre-drilled holes
on the bottom corners of the
table top (#1) and secure
those bolts using the Allen
wrench (#D) to lock them with
the legs (#2).
Turn right (clockwise) to tighten
Page 4 of 5
Enlarged
#A x 8 pcs
#B x 8 pcs
#C x 8 pcs
With the help of another person, carefully turn the
completed table upright. Make sure the table is
rested on a flat surface and it does not feel loose or
wobbly. If it does, double check that the bolts are
secured and properly tighten.

Page 5 of 5
I. To insert the table leaf (#2) unlock the latches located under the
table.
II. Once unlocked, slide outward on both ends of the outer two-
piece table top (#1) until there is sufficient opening to place the
table leaf (#2). Then slide inward on both ends of the outer two-
piece table top (#1) until they are touching and sitting flush with
the table leaf (#2).
III. Secure the parts together by locking the latches located under
the table.
Enlarged
ASSEMBLY IS COMPLETED
#1