Furniture of America CM-AC521 User manual

Assembly Instructions
ASSEMBLY RA TING Tools Required For Assembly:



 

O O O

  
(Included) 
 
(Not Included)

2 PERSONS RECOMMENDED
Page 1 of 10

Do not fully tighten all bolts until steps 9.
Prepare 4 bolts assembly by inserting
washer (#C) onto bolts (#A). Align
upper back rails (#4) and upper front
rail (#3) to the holes of the right panel
(#2). Secure with bolts (#A).
1) Prepare 2 bolts assembly by
inserting washer (#C) onto bolts (#A).
Align middle front rail (#5) to the
hole of the bottom front rail (#7), then
secure with bolts (#A).
2) Align middle back rails (#6) to
the hole of the bottom back rail
(#8), then secure with bolts (#A).

1) Prepare 4 bolts assembly by inserting
washer (#C) onto boles (#A). Align middle and
bottom front rails to the holes facing front of
right panel (#2).
2) Align middle and bottom back
rails to the holes facing back of the
right panel (#2).
Prepare 2 bolts assembly by inserting washer (#C) onto bolts (#A).
Align panel 1 (#9) to the holes of the right panel, then secure with
bolts (#A).

Prepare 2 bolts assembly by inserting washer (#C)
onto bolts (#A). Align panel 1 (#9) to the holes of
the right panel, then secure with bolts (#A).
Prepare 10 bolts assembly by inserting washer (#C) onto bolts (#A). Align
left panel (#1) to the rest of the shelf and secure with bolts (#A).

Align short panels (#11) to the holes
of the shelves as shown in the picture.
Secure with bolts (#B).
Align long panels (#10) to the shelves,
then secure with bolts (#B).

Attach and adjust adjustable floor protectors according to ground level.
Fully tighten all bolts
Tipping restraint optional.
Align iron connector (#G). to top of shelf, then secure
with screws (#E).

Create your own hole and screw iron
connector (#G) to the wall with
screws (#F).