Furniture of America Hillsview CM3916PC-PK User manual

I. Align the seat (#2) with the pre-drilled holes of the backrest with legs (#1).
II. Prepare 2 bolt assemblies by inserting FIRST the lock washer (#D) onto the
bolt (#C) and then the flat washer (#E) onto that SAME bolt (#C), in that order.
Insert the bolt assemblies through the pre-drilled holes in the center of the seat
(#2). Secure using the Allen wrench (#F).
Prepare 4 bolt assemblies by FIRST
inserting the lock washer (#D) onto the
bolt (#A) then the flat washer (#E) onto
that SAME bolt (#A), in that order. Insert
into the back corners of the seat (#2)
and secure using the Allen wrench (#F).
Place the backrest with legs
on a protected surface
Note: Right and left are determined
by facing the FRONT of the chair
in its upright position.

I. Align the front right leg (#3R) and left leg (#3L) to the seat (#2).
II. Prepare 4 bolt assemblies by FIRST inserting the lock washer (#D) onto the bolt (#B) then
the flat washer (#E) onto the SAME bolt (#B), in that order. Insert the bolt assemblies through
the pre-drilled holes in the corners of the seat (#2) and secure those bolts using the Allen
wrench (#F).
I. Attach the front leg support and R&L supports in the designated
slots along the legs.
II. Insert the wood screw (#G) at a diagonal and secure using a Phillips
screwdriver. Tighten screws until properly secure.
ASSEMBLY IS COMPLETED