Furniture of America Nautia CM-BK629 User manual

2. Place the lower front
and back side panels
(#5,6) onto those bolts.
Secure using the Allen
wrench (#K).
FRONT
BACK
LEFT
RIGHT
1. Insert 2 bolts (#A) into
each side of the lower
end guardrails (#1,2),
then apply a barrel nut
(#B) onto each bolt (#A).
1. Insert 2 bolts (#A)
into each side of of
the upper end
guardrails (#3,4).
2. Insert 2 barrel nuts
(#B) into each end of
the upper front side
rail (#7), then place
each end onto the
bolts (#A). Make sure
the bolts are inside
the nuts, then secure.
4. Insert the bolts (#A) into the holes along the upper
end guardrails (#3,4), then insert the barrel nuts (#B)
into each end of the back guard rails (#9) and upper
back side rail (#8). Place onto the bolts and secure.
3. Insert a wood dowel (#H) into each end of the back guardrails (#9),
then insert into the top holes along the upper end guardrails (#3,4).
LEFT
RIGHT
FRONT
BACK

1. Insert a wood dowel
(#H) into one end of
the front guardrails (#10),
then insert into the top
holes along the upper
end guardrail (#3).
2. Insert the bolts (#A) into the holes along the upper end guard-
rail (#3), then insert the barrel nuts (#B) into each end of the
front guardrails (#10). Place the ends onto the bolts and secure.
Note: Make sure the
bolts enter the nut.
3. Insert a wood dowel (#H) into the
remaining ends of the front guard-
rails (#10), then apply the guardrail
bar (#12) onto those dowels. Align
the holes and insert bolts (#A) into
the top holes and bolts (#F) into
the bottom holes. Secure.
Align the guardrail supports (#11) to the holes along the
guardrails, then insert 3 bolts (#F) into each. Secure.

Insert a metal dowel (#G) into
each hole along the top of the
bottom bed, then carefully place
the top bed onto those dowels.
Align the support woods (#18) to the rear holes,
then insert 2 bolts (#D) into each and secure.

1. Insert each end of the ladder rungs (#16,15)
into the slots along the ladder rails (#13,14).
Note, ladder rung (#16) is placed on top and
the rest are ladder rungs (#15). After that,
insert a bolt (#C) into each end and secure.
2. Insert 2 wood dowels (#H) into
the holes along the right ladder
rail (#14), then place the ladder
rail support (#17) onto those
dowels. Insert 2 screws (#I).
Secure using a screwdriver.
Align the top end and bottom end of the
ladder to the rails, then insert 2 bolts (#E)
into each end. Secure using the Allen wrench.
LEFT
RIGHT

Align the support legs (#19) to the holes along
the full slat kit (#21), then insert a screw (#J)
into each. Secure using a screwdriver.
Place the twin slat kit (#20) onto
the top bed and the full slat kit
(#21) onto the bottom bed, then
insert a screw (#I) into each hole
and secure using a screwdriver.