Furniture of America CM-AC293 User manual

EASY
The Assembly Rating is a 5-point system that
shows the degree of effort needed in
assembling a specific product (with 1 being
easy and 5 being difficult). For some
products, two persons are recommended.
Allen Wrench (Included)
Assembly Instructions
Tools Required for Assembly:
Rev.14-03-11
Page 1 of 5
DIFFICULT
ASSEMBLY RATING
CM-AC293
Phillips Screwdriver (Not Included)

Page 2 of 5

Parts List Hardware List
#1 x 1 pc
Left Stand
#2 x 1 pc
Right Stand
#3 x 1 pc
Shelf A
#A x 20 pcs
Bolt 1/4”x1-1/4”
#B x 1 pc
Allen Wrench
Before you begin, please read Page 2
of “Assembly and Care Advice”.
And remember, do not tighten until
each step is completed or instructed.
MD
Page 3 of 5
#4 x 1 pc
Shelf B
#5 x 1 pc
Shelf C
#6x 1 pc
Shelf D
#7 x 1 pc
Shelf E
#C x 2 pcs
Wall Anchor
#D x 2 pcs
Wall Screw
#E x 2 pcs
Screw
#F x 2 pcs
Wall Strap

Step 1 I. Align shelf A (#3) with the 2 pre-drilled holes towards the
top of the left stand (#1).
II. Insert the two bolts (#A) through the two holes of shelfA
(#3) and secure those bolts using the Allen wrench (#B) to
lock them in with the left stand (#1).
III. Repeat the above process to assemble shelf B (#4)
through shelf E (#7) in that order.
Step 2 Repeat Step 1 to assemble the right stand
(#2) to all the shelves (#3 through #7).
Turn right (clockwise) to tighten
Turn right (clockwise) to tighten
Page 4 of 5
#A x 10 pcs
Enlarged
Enlarged
Note: Right and left is determined by standing in
FRONT of the unit in its upright position.
#A x 10 pcs

Step 3 Carefully turn the completed unit upright. Make sure the unit
is rested on a flat surface and it does not feel loose or
wobbly. If it does, double check that the bolts are secured
and properly tighten.
Step 4
I. Insert the screw (#E) near the end of the
the wall strap (#F) and tighten that screw
using a Phillips screwdriver to secure it
with the right stand (#2). Repeat the
process for the other side.
II. Select a location where you want to the
unit to be displayed. Mark on the wall the
two locations where the wall anchors (#C)
will be placed. Drill a hole for each anchor
slightly smaller then the size of the screw.
Push the wall anchor (#C) as far as it will
go with your finger. Tap gently with a
hammer until the wall anchor (#C) is flush
with the wall surface.
III. Insert the wall screw (#D) through the
other end of the wall strap (#F) and tighten
that screw using a Phillips screwdriver
into the wall anchor. Repeat the process
for the other side.
Turn right (clockwise) to tighten
Page 5 of 5
ASSEMBLY IS COMPLETED
SECURING THE DISPLAY TO THE WALL
#C x 2 pcs
#D x 2 pcs
#E x 2 pcs
#F x 2 pcs #2
#1