Furniture of America Sahara CM1637 User manual

Align twin slat kit (#5) with pre-drilled holes along
the sides of the rear rail (#3) and front rail (#4).
Then secure by screwing in the screw (#G) using
a Phillips screwdriver.

Align the second twin slat kit (#5) with pre-drilled holes along
the sides of the back panel (#7) and front frame (#6).Then
secure by screwing in the 6 screws (#G) using a Phillips
screwdriver.
I. Insert 2 wood dowels (#E) into the pre-drilled holes along the sides of the front frame (#6) and
2 more in the pre-drilled holes of the back panel (#7) . Repeat the process on the other side.
II. Align the pre-drilled holes on the left end panel (#9) with the wood dowels in the front frame (#6)
and back panel (#7). Insert until secure. Repeat process on the other side with the right end
panel (#8).
III. After that, insert the bolts (#F) into the pre-drilled holes using the Allen wrench (#K).
Insert screws into pull handle (#H) using a Phillips screwdriver.

ASSEMBLY IS COMPLETE
Insert trundle