Furniture of America Therese CM-BK628 User manual

Align the lower side rails (#7,#8) to the lower end guardrails (#1,#2). Insert barrel nuts
(#B) to the side rails (#7,#8), then secure with bolts (#A) by using the Allen wrench (#I).
2) Align lower front side rail (#9) to the lower end guardrails
(#3,#4). Insert barrel nuts (#B) to the side rail (#9), then
secure with bolts (#A).
1) Align lower back side rail (#10) and two back guardrails (#12) to
the end guardrails (#3,#4). Make sure to insert wood dowels (#F) to
each end of the back guardrails (#12). Insert barrel nuts (#B) to the
side rail (#10) and back guardrails (#12), then secure with bolts (#A).

1) Align front guardrail (#13) to end guardrail (#3). Make sure to insert dowels
(#F) as shown in the picture. Insert barrel nuts (#B) to the front guardrail (#13),
then secure with bolts (#A).
2) Place back piece
(#14) to front and back
guardrail (#12,#13) as
shown in the picture.
Secure with bolts (#D).
2) Align upper side rail (#11) to the upper end guardrails (#5,#6). Insert barrel nuts
(#B) to the side rail (#11), then secure with bolts (#A).
1) Align lower back side rail
(#10) and two back
guardrails (#12) to the end
guardrails (#5,#6). Make
sure to insert wood dowels
(#F) to each end of the back
guardrails (#12). Insert barrel
nuts (#B) to the side rail
(#10) and back guardrails
(#12), then secure with bolts
(#A).

Insert metal dowels to each bunk beds,
then stack them up as shown in the
picture.
2) Place back piece (#14)
to front and back guardrail
(#12,#13) as shown in the
picture. Secure with bolts
(#D).
1) Align front guardrail (#13) to end guardrail (#6). Make sure to insert dowels
(#F) as shown in the picture. Insert barrel nuts (#B) to the front guardrail (#13),
then secure with bolts (#A).

Align ladder rung (#19) to ladder rails (#16,#15), then secure with screws (#E).
Align ladder rung (#19) to ladder rails (#17,#18), then secure with screws (#E).

Place the twin slats (#20) on each level of
the bed, then secure with screw (#H) by
using a screwdriver.
1) Insert the dowels (#F) to the
ladder, then align the ladders
according to the height of of bunk
bed.
2) Secure the ladder to the bunk
bed with bolts (#C) by using the
Allen wrench (#I).