
Fig 1. Pull up
Fig 2. Pull down
Fig 3
Fig 4
1. Setting the On/O periods
Daily Plug-in Timer:
This timer can set up to 24 On/O
commands a day.
Using your finger, a pen or screwdriver
pull up all the segments that correspond
to the desired “O” period. For the
desired “On” period, make sure the
segments are pushed down.
Each segment represents 30 minutes.
2. Setting the time:
Turn the dial clockwise until the
triangular pointer is pointing at the
actual time. Ensure that the switch
on the side of the unit is set to the
position.
3. Connection
Once the desired On/O periods and
actual time are
set, plug the Timer into the wall socket,
and then the appliance’s plug into the
Timer. Ensure the wall socket and the
appliance are on.
The Timer will start to operate and switch
on and o the appliance according to the
pre-set On/O commands.
alway
on
mode
timer
on
mode