G2 UPS-100 User manual

Quick Start Guide UPS-100
UPS-100 Quick Start Guide
General Layout
1- Inverter
2 - UPS 220V Output
3 - 220V Input
4 - Battery Location
5 - Positive Battery Terminal
6 - Negative Battery Terminal
7 - Battery Fuse 20A
8 - Charge Controller
1 - Remove Back Plate by removing the 4 nuts and washers (1 in each corner)
G2 Security PTY Ltd Page 1

Quick Start Guide UPS-100
2 - Mount Enclosure onto wall using suitable fixings
3 - Reinstall plate
4 - Place supplied battery (4) in the enclosure (bottom RHS)
5 - Attach the negative (6) and positive (5) terminals to the battery with the supplied screws and
washers (inside the accessory pack attached to the battery leads) NOTE only use LIFePO4
batteries as this is what the charge controller has been programed to charge, It is not suitable
for Lead Acid Batteries
The LED lights of the charge controller will come on.
G2 Security PTY Ltd Page 2

Quick Start Guide UPS-100
6 - Secure the battery with the cable tie.
7- Terminate mains 220VAC supply to the bottom fuse terminal (3).
8 - Once power is supplied the charger will light and the LED sequence on the charge controller
will change.
You can now terminate the feed cable to the Fire panel from the upper fuse terminal (2)
Once you are ready to power up the attached equipment you can switch the inverter (1) switch
to the ON position where it indicates with 1 |. Do not switch to 2 bar || symbol as this is the
incorrect setting and may not power your fire panel.
G2 Security PTY Ltd Page 3