Gainsborough K340 User manual

Set 2 Bloom Illuminating Solar Lights
K340 v001: 31/12/21
Please read and retain these instructions for future reference
ALWAYS POSITION IN DIRECT SUNLIGHT
ASSEMBLY INSTRUCTIONS / INSTRUCTIONS FOR USE:
Unpack the components carefully. Please check all parts have been removed from the packaging.
Before using first time
Remove the protective film from the solar panel.
CHARGING AND OPERATION:
1. Set switch (located on the back of solar case) to “ON” position. Charge the solar product by placing it
under direct sunlight for at least 8 hours.
2. The light will work automatically. It will charge under direct sunlight during the daytime and
illuminate at night.
3. Leave the switch to “ON”position.
NOTE: In order to test the lights simply cover the solar panel with your hand and the light should turn on
automatically.
Find an ideal Place for the Solar Light.
Place the solar light in an area where it will receive direct sunlight for at least 8 hours per day. The number of
hours the light will illuminate is directly proportional to the hours of sunlight it receives. If the light is placed
in a shaded area, it will not be able to fully charge and its illumination time will be limited. Do not place the
light near other outdoor lighting like porch or streetlights. These may fool the sensor and keep the light from
coming on, or cause it to turn off automatically
To easily insert stakes into the ground, it is recommended to wet the ground first. To avoid damaging garden
stakes when inserting into the ground, select a spot in soft, rock-free soil. Insert the base of the stake first
Dimensions
Height 50cm,spacing 50cm
•2 X 2 FLEXIBLE LIGHTS TO DIRECT LIGHT ON THE
PLANTS
•POLYCRYSTALLINE SOLAR PANEL
•LEAD WIRE FROM LIGHTS TO SOLAR PANEL:
100CM
•WARM WHITE LED INSIDE EACH HEAD
•SOLAR POWERED, AUTOMATICALLY TURNING
ON/ OFF AT DUSK AND DAWN
Batteries Required: 1x AA 1.2v 400Mah, Ni-MH,
Rechargeable (Included)

Set 2 Bloom Illuminating Solar Lights K340 Instructions for Use
Please read and retain these instructions for future reference v001: 31/12/21
then gently insert the rest of the stake into the base. DO NOT push directly against the solar cell or the
ornament housing containing the actual LED light.
Replacing Battery
If solar product does not light up after it has been used for around 8 –12 months, replace the rechargeable
battery as it may be weak or worn out. (Battery 1x AA 1.2v 400Mah, Ni-MH, Rechargeable–Same equivalent
type as recommended must be used).
Step 1: Unscrew the battery compartment cover by using a Phillips head screwdriver (not included) .
Step 2: Remove the exhausted battery and install 1x AA rechargeable battery according to the +/- polarity as
beside image. Open the compartment carefully and ensure that wire inside the battery terminals is not
damaged.
Step3: Replace battery compartment cover, screw it back into position and make sure is properly sealed.
Step 4: Charge the solar product by placing it under direct sunlight for at least 8 hours.
Care and Maintenance Recommendations
1. Clean solar panel with a soft sponge every couple of weeks.
2. Make sure all connectors are still tight and no water getting in.
BATTERIES
•Keep batteries away from children and pets.
•Do not mix used and new batteries.
•Remove the batteries if left for long periods.
•Never dispose of batteries in a fire.
•Battery disposal, spent or expired batteries must be properly disposed of and recycled in compliance
with local regulations. For detailed information, contact your local authority.
•Follow the battery manufacturer’s safety, usage, and disposal instructions.
DISPOSAL
•Coopers of Stortford use recyclable or recycled packaging where possible.
•Please dispose of all packaging, paper, cartons, packaging in accordance with your local
recycling regulations.
•Plastics, polybags –this is made from the following recyclable plastic.

Set 2 Bloom Illuminating Solar Lights K340 Instructions for Use
Please read and retain these instructions for future reference v001: 31/12/21
Code &
Symbol
Type of
Plastic
ABS
Commonly
used for
CD’s, crisp packets, various flexible packaging, baby bottles, sunglass lenses
Notes
Not often or widely recycled
•At the end of the product’s lifespan please check with your local council authorised household waste
recycling centre for disposal.