Gajah International GD66CT User manual



GD66CT Speaker
Quick Start Guide

GD66CTQuickStartGuide

Parts and Control
TopView FrontView BottomView
Getting Started
Carefully remove the speaker from packet.
Charging
When battery power is low, charge the speaker by connecting GD66CT to a
computer or USB power adapter via the supplied USB cable.
The LED on the side with Power button and Volume+/ button will turn red,
indicating that it is on charging mode.
The LED will turn off when fully charged.

GD66CTQuickStartGuide

Turning on the speaker/bluetooth
•To turn on the Portable Speaker, press and hold the Power button for
about 3 seconds until you hear a beep, then the LED indicators on Power/
Volume +/- button will blink in blue.
•Continuously press and hold the Power button for 2 seconds to turn on the
bluetooth, then you will hear another beep.
Turning off the speaker/bluetooth
•To turn off the portable speaker, press and hold the Power button for
about 3 seconds to turn off the bluetooth, then you will hear a beep.
•Continuously press and hold the Power button for 2 seconds to turn off the
Portable Speaker; then you will hear another beep, and the LED indicators
on the Power/ Volume +/- button will turn off.
Playing music
Please follow the below steps to play music.
1. Unwind the connector cable around the portable speaker base.
2. Plug the connector to the music source,e.g. PCs/laptops, MP3 players or
radios.
3. Turn on the Portable Speaker.
4. Start playing the selected music or radio from the music source.

GD66CTQuickStartGuide

Adjusting the volume level
Press the Volume+ or Volume- button to increase or decrease the level of
the volume.
When the volume level is the maximum or minimum, you will hear a alarm
beep.
Setting Bluetooth mode
1. Turn on the Portable Speaker and turn on the bluetooth.
2. The bluetooth device of music source will search for GD66CT speaker,
then select the “GD66CT” and pair the GD66CT speaker with the Bluetooth
device.
3. Start playing the selected music or radio from the music source.
4. Press the Volume+ or Volume- button to go to next/previous song; Press
and hold to adjust the volume level.
5. Press the Power button to play/pause the music playback.
Note: If there is no response on the speaker, press the Reset button at the
bottom of the speaker.
FCC Caution
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate the
equipment.

GD66CTQuickStartGuide

This device complies with part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and(2) this device must accept any interference received,
including interference that may cause undesired operation.