Gama Sonic BAYTOWN II User manual

BAYTOWN II
SOLAR HANGING
LIGHT WITH GS
LED SOLAR BULB
REMOTE CONTROL
Model: 105BCX01/ 105BCX21
Version 1.2
US Patent #9458970 #7172307
Instruction Manual

For optimum light duration throughout the night, it is very important to place the solar panel in a spot
where it can receive the maximum amount of direct sunlight throughout the day.
page 2
Thank you for your purchase. GAMA SONIC® solar charged lights are brighter and last all night with a full day solar charge.
Unique designs, superior light output, and numerous installation options confirm the outstanding value of our product.
For technical assistance and more information call our Toll-Free number:
800-835-4113 (only within the US)
Or
visit our website or download the latest version of your instruction manual:
www.gamasonic.com Or www.gamasonic.com/user-guides
Please read the instruction manual carefully to obtain the best results from your purchase.
NOTE: In some cases, the batteries would come empty out of the box. Let the solar light
charge for two sunny days in the “ON” position for the batteries to get fully charged.
WARNING: GAMA SONIC® Light bulbs are built and
designed for Gama Sonic products only. They are not
designed to be used in other electrical sockets.
For the same reason, regular AC and/or Low Voltage
bulbs cannot be used in Gama Sonic products.
Assembly Instructions:
1. Screw the
finial to the
lamp base.
2. Connect the
lamp fixture to
the base using
4 screws.
3. Slide the lens
into the lamp
fixture.

page 3
Operation Switch
4. Install the GS Solar LED
Bulb to the light cap.
9. Place the Remote-Control Sensor on the
underside of the location for the solar panel,
where it can be exposed for clear operation.
Install by peeling the adhesive cover and
attaching it to the surface.
8. Connect the wires together and
tighten it firmly to avoid water
getting inside the connection.
5. Install the light
cap to the lamp
fixture.
Secure using the
two screw caps.
6. Install the ceiling
mounting bracket at the
desired location using
the supplied screws.
7. Install the solar panel in
a position where it will
be exposed to the sun,
make sure the wire can
reach the lamp.
NOTE: When installing the GS Solar LED Bulb, hold it from its silver base not by the glass.
9
. Place the Remote-Control Sensor on the
underside of the location for the solar panel,
where it can be exposed for clear operation.
Install by peeling the adhesive cover and
Install by peeling the adhesive cover and
attaching it to the surface.
. Install the solar panel in
a position where it will
be exposed to the sun,
make sure the wire can
NOTE: Before installing the
solar panel, make sure to
switch the On/Off switch
to the ON position, located
under the solar panel.

RC1 RC2 RC3
RC4 RC6
10. Hang the remote-control case using one screw.
The remote-control slides in and out from the
bottom, see for more details.
1. Click any key to turn the
remote-control ON
2. Use Auto mode for automatic
dusk-to-dawn operation
3. Use Manual mode to turn the
light On and Off as desired.
4. On both modes, you can choose between
High and Low brightness settings.
5. The remote-control power will turn OFF
automatically
6. Once the battery is low on power, the
remote control will blink
Remote Control /
Operation Instructions
page 4
2)) 1 $872
+,*+ /2:
3UHVVDQ\NH\WR
WXUQ21UHPRWH
-'3'954/)
952'8.'4-/4-2/-.:
\KX
0$18$/
2)) 1 $872
+,*+ /2:
3UHVVDQ\NH\WR
WXUQ21UHPRWH
-'3'954/)
952'8.'4-/4-2/-.:
\KX
0$18$/
2)) 1 $872
+,*+ /2:
3UHVVDQ\NH\WR
WXUQ21UHPRWH
-'3'954/)
952'8.'4-/4-2/-.:
\KX
0$18$/
1 $872
/2:
3UHVVDQ\NH\WR
WXUQ21UHPRWH
-'3'954/)
952'8.'4-/4-2/-.:
\KX
2)) 1 $872
/2:
3UHVVDQ\NH\WR
WXUQ21UHPRWH
-'3'954/)
952'8.'4-/4-2/-.:
\KX
2))
0$18$/ 0$18$/
+,*+ +,*+
2)) 1 $872
+,*+ /2:
3UHVVDQ\NH\WR
WXUQ21UHPRWH
-'3'954/)
952'8.'4-/4-2/-.:
\KX
0$18$/

page 5
Maintenance
Clean the solar panel regularly with a damp towel to guarantee optimum performance. Do not use any type
of solvent for cleaning and be careful not to put too much pressure on the solar panel while cleaning
• After several years of use, the battery may need replacing.
• This product comes with two battery compartments, and one battery installed. If your solar panel is
exposed to the sun for more than 4 hours a day, you can choose to add another battery, the second battery
will extend the light duration, especially on cloudy days. It will not change the brightness of the lamp.
Replacing the Solar Panel Batteries
1. Detach the solar panel and flip it over.
2. Unscrew the battery compartment screws located
on the back if the solar panel and remove the
compartment door.
3. Unclip the connector and remove the old
battery. Make sure the new battery is a Gama
Sonic - 3.2V/3,000mAh, Li-ion Rechargeable
Battery with a connector.
4. Clip on the new battery and install it into the
battery compartment. Screw back the battery
compartment door.
Optional Battery Included Battery

page 6
WARNING: Do not dispose of Li-Ion battery in the regular trash, municipal waste stream or by
fire as batteries may leak or explode. Do not open, short circuit, or mutilate batteries as injury
may occur. Preserve our environment by recycling Li-Ion batteries or disposing of them in
accordance with local, State and federal regulations. Do not mix old and new batteries.
Trouble Shooting
If your solar charged light does not come on at dusk despite
observance of all the instructions, please try the following steps:
1. Make sure that the solar light is not being affected by any other light source.
2. Ensure the solar light is not positioned in the shade during the day.
3. Make sure the switch in the lamp head is in the” ON” position.
4. Check that the batteries are installed correctly.
NOTE: The performance of the solar light will vary with the time of year. It will deliver
longer duration when it has had a full day in the sun rather than a day in overcast
weather.
WINTERTIME TIPS: For optimal performance, be sure to remove any snow or debris
accumulation from solar panel(s). A solar panel free of debris will charge the batteries
much more efficiently.
WARNING: Please keep out of reach of children.
Replacing the Remote-Control Battery
• After several years of use, the battery may need replacing.
• This battery is available at any hardware/convenience store
** Gama Sonic batteries and bulbs are available at www.
gamasonic.com You can purchase it directly at:
https://gamasonic.com/product-category/parts-and-accessories/
• Make sure the new battery is a
Gama Sonic - 3.2V/3,000mAh,
Li-ion Rechargeable Battery with a connector.
• Make sure the new bulb you purchase is compatible
with this model (A60 bulb)
1. Slide the remote-control out of its case.
2. Press button to the side and pull the
battery tray out to replace the battery