Gama Sonic GS-97-SP User manual

1
Introduction
Thank you for your purchase. GAMA SONIC® solar charged lighting eliminates the
problems associated with most solar lighting available today. GAMA SONIC® solar charged
lights are brighter and last all night with a full day solar charge. Unique design, superior light
output and numerous installation options confirm the outstanding value of our product.
GAMA SONIC® has been recognized as a worldwide leader in the lighting industry for over
20 years. The company also offers unique multi-purpose rechargeable products that range
from party lights to emergency lighting products.
For technical assistance and more information call our Toll Free number:
800-835-4113 (only within the US)
Visit our website or download the latest version of your instruction manual:
www.gamasonic.com Or www.gamasonic.com/user-guides
Please read the instruction manual carefully to obtain the best results from your purchase.

2
Fig. 3
Fig. 4
B
A
Fig 5
C
B
Fig 6
Assembly Instructions
1. Mark three holes using the template and drill the holes using a 0.5-inch drill
bit, into a solid surface no smaller than the fastening screws. The holes shall
be lined up with the holes of the lamp base
2. Put the fastening screws (included) into the drilled holes with their threaded
ends facing up (Fig 3).
3. Place lamp base onto fastening screws and secure base with the nuts using a
wrench (Fig 4).
4. Make sure the lamp base (A) is stable before proceeding in installation.
5. Place part (B) over part (A) and using a wrench tighten the three screws that
are provided. Make sure that the rubber washers go between part (A) and
part (B) (Fig 5).
6. Place part (C) over part (B) and tighten with a Philips head screwdriver the
four screws that are provided (Fig 6).

6 Easy steps on how to install sleeve anchors.
After using the base as a template and marking the three holes.
1. Use an electric drill with a bit the size of the *sleeve, drill a hole 2.5” deep in the
desired spots (FIG 1).
2. Clean the hole from residue from the drilling.
3. Place the sleeve and anchor into the hole and make sure to leave 2” exposed (FIG 2).
4. Place the First washer over each anchor, then place the base of your unit over the
screws (FIG 2).
5. Place the second washer and spring washer over the unit and tighten clockwise with
the provided nuts (FIG 3).
6. After finishing place the black decorative cap over the nuts.
FIG 2
First washer
FIG 3
Nut
Spring washer
Second washer
*The sleeve is the outer part that is covering the screws
FIG 1