Gama Sonic DPEZ5F0 User manual

5’ DECORATIVE POST WITH EZ KIT
Part #: DPEZ5F0, DPEZ5F5
Version 1.1
Instruction Manual

page 2
Thank you for your purchase! GAMA SONIC®solar charged lights are brighter and last
all night with a typical solar charge. Unique design, superior light output and numerous
installation options confirm the outstanding value of our product. GAMA SONIC®has
been recognized as a worldwide leader in the lighting industry for over 20 years.
Technical Assistance/Warranty Claims/Replacement Parts
Toll Free Number: [phone] (only within the US) or www.gamasonic.com
Visit our website or download the latest version of your instruction manual:
www.gamasonic.com or www.gamasonic.com/user-guides
Please read the instruction manual carefully to obtain the best results from your purchase.
For best results, the solar light must
be charged in the “ON” position (High
or Low) for at least 2 days of full direct
sunlight.
Gama Sonic’s EZ Anchor allows you to
mount your solar lamp anywhere in your
yard without needing to pour concrete.
Simply install the EZ Auger into the
ground where you want your lamp and
secure the post to it.
A= Base Pole
B= Middle Pole
C= Top Pole
D= Spacer Pole
E= Fitter Adapter
F= Mini Fitter
G= Auger
H= Base Plate
I= Turning Bar
EF
D
C
B
A
H
G
I
Anchors
For optimum light duration throughout
the night, it is very important to mount
your solar lamp in a spot where it will
receive the maximum amount of direct
sunlight throughout the day.
GAMA SONIC’S EZ ANCHOR 2. What's in the Box
1. Solar Lamp Location

3. Assembly Instructions
page 3
1. Remove the base plate (H) from the base pole (A) by
removing the screw caps, nuts, and washers from each of
the three screw studs.
Installing in concrete
- Using the base plate (H) as a template and mark where
the three holes will need to be drilled.
- Drill three holes in the concrete no larger than the
provided anchors.
- Insert the three anchors into the holes and secure
the base pole to the concrete by tightening the three
anchors.
- Continue to Step 2
Installing using the EZ Anchor
- Place the turning (I) bar through the hole at the top
of the auger (G) and begin twisting the auger (G) into
the ground clockwise. Use downward pressure while
turning.
- Occasionally check the level tool on the auger (G) to
ensure the auger is vertical.
- Stop turning once the ring on the auger (G) is flush
with the ground.
- Slide the base plate (H) over the auger and secure it
with the large nut and bolt.
- Re-install the base pole (A) to the base plate (H) and
secure with the washer, nut, and screw caps removed
in step 1.
2. Attach the middle pole (B) to the base pole (A) and secure
with the three provided screws.
3. Attach the top pole (C) to the middle pole (B) by screwing
them together.
4. Attach the spacer pole (D) to the top pole (C) by screwing
them together.
5. Attach the fitter adapter (E) to the spacer pole (D) by
screwing them together.
6. Mount your 3” lamp to the fitter adapter (E) and secure
using the setscrews on the lamp.
E F
or
D
C
B
A
H
G

Optional Mini Fitter
This lamp post comes with an optional mini fitter to attach your Gama Sonic lamp with a smaller fitter for a sleeker look. Follow
the instructions below to install it.
• Remove the fitter adapter (E) from the post and remove the 3” Fitter from your Gama Sonic lamp.
• Attach the mini fitter (F) to the lamp and secure using the lamps hardware.
NOTE: in the event you cannot secure the mini fitter with your lamp’s hardware, you can replace it with the nut and bolt
included with the mini fitter. Each lamp is different and may require additional steps to remove the old fitter and install
the mini fitter.
• Attach the lamp with mini fitter (F) to the spacer pole (D) by twisting clockwise.
Maintenance
Clean the solar panels regularly with a damp towel to guarantee optimum performance. Do not
use any type of solvent for cleaning and be careful not to put too much pressure on the solar
panels while cleaning.
Troubleshooting
If your solar light does not come on as expected despite observance of all the instructions,
please try the following steps:
1. Make sure that the solar lamp is not being affected by any other light source.
2. Ensure the solar lamp is not positioned in the shade during the day.
3. Check that the batteries are installed correctly.
NOTE: The performance of the solar lamp will vary with the time of year. It will last longer
when it has had a full day in the sun rather than a day in overcast weather.
WINTERTIME TIPS: For optimal performance, be sure to remove any snow or debris
accumulation from solar panel(s). A solar panel free of debris will charge the batteries much
more efficiently.
WARNING: Please keep out of reach of children. Do not dispose of the Li-Ion battery in the regular trash,
municipal waste stream or by fire as batteries may leak or explode. Do not open, short circuit, or mutilate
batteries as injury may occur. Preserve our environment by recycling Li-Ion batteries or disposing of them in
accordance with local, State and federal regulations. Do not mix old and new batteries.
page 4
Replacement parts are available at
www.gamasonic.com or call [phone] (only within the US)