Gama Sonic Everest GS-109S-B User manual

EVEREST SOLAR LAMP POST
Instruction Manual

Introduction
Thank you for your purchase. GAMA SONIC® solar-charged accent lighting eliminates
the problems associated with most solar lighting available today. GAMA SONIC® solar-
charged lights are brighter and last all night with a typical solar charge. Unique design,
superior light output and numerous installation options confirm the outstanding value of
our product.
GAMA SONIC® has been recognized as a worldwide leader in the lighting industry for
over 20 years. The company also offers unique multi-purpose rechargeable products
that range from fans with built in radios to emergency lighting products.
Please read the instruction manual carefully to obtain the best results from your
purchase.
Solar Light Location:
For optimum light duration throughout the night, it is very important to place your solar
light in a spot where it will receive the maximum amount of direct sunlight throughout
the day.
Note: The unit will operate optimally after 2 full days of charging in direct sun, and in the
“on position
WARNING: GAMA SONIC® Light bulbs are not to be used in other electrical
sockets these are low-voltage light bulbs that are built and designed for our
products only!

What’s Inside
Open your package and remove the contents. Check to make sure all pieces are
present and accounted for.
Tools needed:
Tools that are needed but not supplied with the solar lamp post set are: a screw driver,
a wrench and an electrical drill that will be used to anchor the lamp base to the ground.
B
A
A
A
A
D
A
E
A
F
A
C
A
B
A
G
F
A
A
B
A
GS-109S
GS-109F

Operation Instructions
Turn the On/Off switch on the lamp head (B) to Economy
or High position. Economy lasts longer using dimmer light,
High- Brighter light output
(Fig. 1).
Installation Instructions
NOTE: If you are replacing an existing gas/electric post light, you must consult a
certified technician to cancel them before installation.
GS-109S
1. Use an electric drill to make three holes into a solid surface no smaller than the fastening
screws (G). The holes shall be lined up with the holes of the lamp base (F).
2. Put the fastening screws (G) into the drilled holes with their threaded ends facing up.
3. Place lamp base onto fastening screws and secure base with the nuts using a wrench.
Cover the bolts with the plastic covers provided.
4. Make sure the lamp base (F) is stable before installing Part (E).
5. Place part (E) on top of part (F) and tighten with the provided screws using a wrench.
6. Screw part (D) to part (E), part (C) to part (D) and part (B) to part (C).
GS-109F
Install the lamp onto your existing 3” post, using the screws provided
Replacing the Batteries
After several years of use, the battery may need
replacing.
1. Remove the two screws holding the battery
compartment lid. (B) (Fig. 2)
2. Remove the lid to expose the inside.
3. Unplug the batteries inside and replace them with
the new batteries using the clips.
Fig. 1
Fig. 2

WARNING: Do not dispose of Li-Ion battery in the regular trash, municipal waste
stream or by fire as batteries may leak or explode. Do not open, short circuit, or mutilate
batteries as injury may occur. Preserve our environment by recycling Li-Ion batteries or
disposing of them in accordance with local, state and federal regulations. Do not mix old
and new batteries.
Maintenance
Clean the solar panels regularly with a damp towel to guarantee optimum performance.
Do not use any type of solvent for cleaning and be careful not to put too much pressure
on the solar panels while cleaning.
Troubleshooting
If your solar charged light does not come on at dusk despite observance of all the
instructions, please try the following steps:
1. Make sure that the solar light is not being affected by any other light source.
2. Ensure the solar light is not positioned in the shade during the day.
3. Make sure the switch in the light is the ON position.
4. Check that the batteries are installed correctly.
Note: The performance of the solar light will vary with the time of year. It will deliver
more light when it has had a full day in the sun rather than a day in overcast weather.
Wintertime Tips: For optimal performance, be sure to remove any snow or debris
accumulation from solar panel(s). A solar panel free of debris will charge the batteries
much more efficiently.
WARNING: Please keep out of reach of children.