Garmin Etrex Legend - GPS Receiver Installation guide







 
Use the PAGE button on the top
right of the receiver to switch
between the different screens.
The dark bars show the satellites
you are “locked” on. You need at
least
3
b
ars to use the receiver.




Go in the direction the arrow is pointing to
move towards your waypoint or landmark.
NOTE: You must be moving in order for
the GPS unit to determine where you are
and which way you are moving.

  
1 – Press and hold the THUMB STICK until the MARK WAYPOINT screen appears
with the guy holding a flag.
2 – Your waypoint is automatically assigned a three-digit number. To
change the name of the waypoint, use the THUMB STICK button to
highlight its name. Use the THUMB STICK to select the new name for
the waypoint.
3 – When you are done, use the THUMB STICK to highlight the OK
button and press the THUMB STICK button once.
 
1 - Use the PAGE button to find the
main menu. Use the THUMB STICK to
go to the FIND option and press the
same button to select this option.
3 - Select WAYPOINTS by pressing the THUMB STICK button.
4 - Choose NEAREST on the next menu.
5 - Select the waypoint you want using the THUMB
STICK button.
6 - Use the THUMB STICK button to
select GOTO at the bottom of the screen.
7 - Use the navigation screen to help you
locate your destination. You need to move
in the direction of the large arrow. When
you get close to your destination, an
“Arriving at Destination” message will be
displayed.
You can also press the bottom
left button on the receiver to go
directly to the Find screen.
Remember ...
You must be moving
in order for the
receiver to keep track
of your location!