GEIGER GF0029 User manual

GEIGER RADIO SYSTEMS
Sunshade controls
Twilight sensor
GF0029
Operating instructions
1. Switch sensor on and off
Press key ON for 3 seconds.
wThe green LED ashes 3 times
w The sensor is switched on
Press key OFF for 3 seconds.
wThe red LED ashes 3 times
w The sensor is switched off
2. Programming of radio code
Press both keys for 3 seconds
wRed and green LEDs ash alternately
w The program mode is active for
20 seconds
As shown on the picture and within 20 seconds
hold the transmitter close to the GF0029 and
press one transmitter key.
wThe green LED lights up once
w The radio code is successfully learned
You can now program the GF0029 in the receiver, according to the operating instructions of your
controller. By briey pressing the ON key, a sensor signal can be sent manually.
3. Function test
The curtain has to be in the upper end position in order to carry out the function test.
Briey press the ON key
wThe green LED lights up once / the curtain moves downwards
Now briey press the OFF key
wThe red LED lights up once / the curtain moves up again
The function test is completed. If the curtain is in the upper end position, the GF0029 will move it
automatically downwards every day at dusk (threshold 40 lx).
OFF ON
OFF ON
red LED
green LED

Gerhard Geiger GmbH & Co. KG • Schleifmühle 6 • D-74321 Bietigheim-Bissingen
Telephone: [phone] • Fax: [phone] • [email protected] • www.geiger-antriebstechnik.de
100W0672 en 0812
4. Status messages
The green LED ashes once per minute during the day
w The sensor is switched on
The red LED ashes once per minute during the day
w A battery replacement is required
Status messages are not displayed at night.
5. Battery replacement
The battery has an average lifespan of four years under normal usage.
Remove the holder with the suction cup from the sensor housing. With the
screwdriver push down/slightly backwards the holding tabs into the holes.
You can then remove the lid and replace the battery (CR2032, 3V).
6. Declaration of conformity
We herewith explicitly declare that this product complies with the essen-
tial requirements and relevant directives. It is authorised for use in all EC
member states and in Switzerland without any need of prior registration.
The Declaration of Conformity concerning this product is available on our
website: www.geiger-antriebstechnik.de.
7. Notes on waste disposal
Recycling of packaging materials
In the interest of environmental protection, please contact your local government’s recycling or
solid waste management department to learn more about the services it provides.
Waste disposal of electric and electronic equipment
Electronic equipment or batteries cannot be discarded along with the normal household waste.
Keep for more information on the recycling and disposal methods envisaged by the local regula-
tions in your area.
For technical questions, please call our service team at: [phone].
They will be happy to assist you.
Use a screwdriver to press
down the holding tabs