Gembird 3D Printer Filament Dryer Box User manual

3D Printer
Filament
Dryer Box
User Guide

Contents

Size

Size
Package Size 268（L）*145（W）*272（H）mm
Product Size 228（L）*125（W）*242（H）mm
Max Capacity 200*73（H）mm
Product Weight 850g
Rated Power AC100-240V~50/60Hz
Power Output DC24V~2A
Power of Heater 48W
Filament Diameter 1.75mm/2.85mm/3.0mm

Button Introduction

The product has four buttons, the open button
the function button the up button the down button
Press to switch modes and the to change the
parameters
The system will be in dormancy after no-operation for 5 seconds,
the backlight disappears in dormant state, press any button to
wake up, and then press button to set parameters or shut down
Operation setting timing; please refer to the fan position
( illustration of items 1-5 in the previous method of use)
Four Buttons

Method of use

Plug the Adapter into the AC100-240V ~50/60Hz power supply
and plug the output terminal into the interface in the tail of box.
Press the button to turn on, and enter the standby mode after
turning on, the LCD displays 0000
Open the lid; put in the consumable tray; pull out the consumable
from the outlet.
Press the button once to enter the timing setting. Press the
button once to increase the time by 0.5 hours, and the total can be
set to 24 hours;Press the button once to decrease by 0.5 hours,
stop the increase or decrease and set three seconds to start the
countdown; The LED display decreases by 0.1 hours as the unit
display.
Press the button to switch the Heat gear; 1-2-3 gear.Press the
button to adjust cyclically

Level Set for
Temperature&Humidity
Reference Table

Type of filament PLA/PLA+ ABS/ABS+/PETG PVA/Nylon/PC
Level 123
Level Set for Temperature&Humidity Reference Table
Level Set for Temperature&Humidity Reference Table
Level 123
Hot plate TEMP 80℃85℃90℃
Inside TEMP 50-55℃55-60℃60-68℃
Inside humidity 15-20% 10-15% 5-8%
NOTE: Above parameters in the table are testing under 20 ℃of temperature and 62% of
humidity in the room. The temperature and humidity in the box will slightly change due to different
environments