Gemmy AIRBLOW INFLATABLE 221215 User manual

IMPORTANT SAFETY
INSTRUCTIONS
BASIC PRECAUTIONS SHOULD ALWAYS BE
FOLLOWED WHEN USING ELECTRICAL PRODUCTS,
INCLUDING THE FOLLOWING:
READ AND FOLLOW ALL
SAFETY INSTRUCTIONS.
• This is an electrical product - not a toy! To avoid risk of
fire, burns, personal injury, and electric shock, it should
not be played with or placed where small children can
reach it.
• Do not use seasonal products outdoors unless marked
suitable for indoor and outdoor use. When products are
used in outdoor applications, connect the product to a
Ground Fault Circuit Interrupting (GFCI) outlet. If one is
not provided, contact a qualified electrician for proper
installation.
• This seasonal use product is not intended for permanent
installation or use.
• Do not mount or place near gas or electric heaters,
replaces, candles, or other similar sources of heat.
• Do not secure product wiring with staples or nails or place
on sharp hooks or nails.
• Do not let lamps rest on the supply cord or on any wire.
• Unplug the product when leaving the house, when retiring
for the night, or if left unattended.
• Do not use this product for other than its intended
purpose.
• Do not hang ornaments or other objects from cord, wire,
or light string.
• Do not close doors or windows on the product, or
extension cords, as this may damage the wire insulation.
• Do not cover the product with a cloth, paper, or any
material not part of the product when in use.
• Do not place the product against carpeting, furniture, or
any other fabric when in use.
• This product has a polarized plug (one blade is wider
than the other) as a feature to reduce the risk of electric
shock. This plug will t in a polarized outlet only one way.
If the plug does not t fully in the outlet, reverse the plug.
If the plug still does not t, contact a qualied electrician.
Do not use an extension cord unless the plug can be fully
inserted. Do not alter or replace the plug.
• This product employs overload protection (fuse). A blown
fuse indicates an overload or a short-circuit condition. If
the fuse blows, unplug the product from the outlet. Also
Safety Information
221215-E unplug any additional string or products that may be
attached to the product. Replace the fuse as per the user
servicing instructions (follow product markings for proper
fuse rating) and check the product. If replacement fuse
blows, a short-circuit may be present and the product
should be discarded.
• Read and follow all instructions that are on the product or
provided with the product.
SAVE THESE
INSTRUCTIONS
USE AND CARE
INSTRUCTION
1. When the product is placed on a live tree, the tree should
be well maintained and fresh. Do not place on live trees
in which the needles are brown or break off easily. Keep
the tree holder lled with water.
2. If the product is placed on a tree, the tree should be well
secured and stable.
3. Before using and reusing, inspect the product carefully.
Discard any products that have cut, damaged or frayed
wire insulation cords, cracks, lamp holders or enclosures,
loose connections, or exposed copper wire.
4. When storing the product, carefully remove the product
from wherever it is placed, including trees, branches,
or bushes, to avoid any undue strain or stress on the
product conductors, connections and wires.
5. When not in use, store neatly in a cool, dry location
protected from sunlight.
To reduce the risk of re and electric shock:
1. Do not install on trees having needles, leaves or branch
coverings of metal or materials which look like metal and.
2. Do not mount or support wires in a manner that can cut
or damage wire insulation.
CAUTION: Do not attempt to inflate this unit
during unusually strong winds. If it becomes too windy for
safe operation, allow the unit to deate and wait for safer
conditions.
CAUTION: Do not connect to another lighting
string, decorative outfit, or seasonal product. Do not at-
tempt to inflate your Animated Airblown®Inflatable during
unusually strong winds. If it becomes too windy for safe
operation, simply allow your Animated Airblown® Inatable
to deate and wait for better conditions before re-inating.
Protect the electric fan and power cord from direct expo-
sure to water. This precaution will reduce the risk of elec-
trical shock. When the temperature is below 14° F (-10°
C), the motor may temporarily stop running. The motor will
begin functioning again higher temperatures.
WARNING
Remove all plastic fasteners and tags. These are part of
the packaging and should be discarded.
This item is not a toy and should be used for decorative
purposes only.
For indoor and outdoor use.
120 V 60 Hz.
CAUTION
1.For temporary (90 days maximum) installation and use
only.
2.Always unplug this product before installing or replacing
fuses.
3.To reduce the likelihood of excessive heat and possible
damage, use only decorative lamp accessories pac-
kaged with this product.
4. To reduce the risk of fire or electric shock, do not at-
tempt to replace lamps or modify wiring or product.
WARNING: READ AND
UNDERSTAND ALL
INSTRUCTIONS.
Failure to follow all instructions listed below, may result in
electric shock, re and/or serious personal injury.
WARNING:
ELECTRIC PRODUCT. Keep away from children. As with
all electrical products, precautions should be observed du-
ring handling and use to reduce the risk of electric shock. If
the supply cord is damaged, it must be replaced by the ma-
nufacturer, its service agent or similarly qualified persons
in order to avoid a hazard. To avoid the risk of electrical
shock, always make sure the figure is unplugged from the
electrical outlet before assembling, disassembling, or relo-
cating.
This product is to be assembled by adults only.

USER SERVICING
INSTRUCTIONS
Fuse Replacement
WARNING: Risk of Fire:
Replace only with same size and
type of fuse. Do not replace the
attachment plug. Contains a safety
device (fuse) that should not be
removed. Discard product if attachment plug is damaged.
1. Grasp plug and remove from the receptacle or other outlet
device. Do not unplug by pulling on the cord.
2. Open fuse cover. Slide open the fuse access cover on top
of the attachment plug towards blades. (See illustration)
3. Remove fuse carefully.
4. Replace fuse only with 5 Amp Max, 125 Volt (provided with
product).
5. Close the fuse cover. Slide closed the fuse access cover
on top of the attachment plug.
TROUBLESHOOTING
CHECKLIST
If your Animated Airblown® Inatable is not inating, the
problem may be.
1. The power source is disabled or the cord may be
unplugged.
2. Debris may be lodged in the motor.
3. The zipper may not be securely fastened, sealing the
Animated Airblown® Inatable.
4. The temperature may be below 14° F (-10° C).
NOTE: ONCE FAN IS UNPLUGGED AND STOPS
BLOWING, YOUR Animated Airblown® Inatable WILL
DEFL ATE.
WARNING
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this
device must accept any interference received, including
interference that may cause undesired operation.
CAUTION: Changes or modications not
expressly approved by the party responsible for compliance
could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help
These Instructions Are For These Items
221215
FREQUENTLY ASKED
QUESTIONS (FAQ’s)
1. Can I continually run my Animated Airblown®
Inatable?
Yes, you can run your Animated Airblown® Inatable
during the day and at night. We recommend that you
turn off your Animated Airblown® Inatable when
leaving the immediate area and when retiring for the
evening. Otherwise, your Animated Airblown® Inatable
is designed to run continually as you see t.
2. What happens if my Animated Airblown® Inatable
becomes torn?
Rips in the Animated Airblown® Inatable can be sewn
by hand (no special thread is required) or taped with
clear packing tape.
3. How can I clean my Animated Airblown® Inatable?
Wipe clean with a damp cloth and allow to dry before
storing away. Use mild detergent if necessary.
4. When I unplug my Animated Airblown® Inatable,
it deates. Why is this?
Your Animated Airblown® Inatable will not stay inated
unless it is plugged in and the fan is blowing air.
5. My Animated Airblown® Inatable isn’t moving.
What can I do?
It is possible for the action components within your
Animated Airblown® Inatable to become slightly
tangled. If there is no action, attempt to straighten your
Animated Airblown® Inatable to remove wrinkles and
folds. Also, re-check all zippers to insure they are fully
closed. Lastly, recheck the outlet, unplug and plug in
again to insure it is properly plugged in. If this does
not work, please contact Gemmy’s Customer Service
Department.
6. How much electricity does an Animated Airblown®
Inatable consume?
Please refer to the electrical approval label for wattage.
7. What is the best way to store my Animated
Airblown® Inatable?
Store in a bag, box or other storage container and
keep in a cool, dry location.
8. Can I leave my Animated Airblown®up in extreme
weather conditions or freezing temperatures?
We do recommend the consumer take appropriate
precautions to protect the unit. The Animated
Airblown®will operate at temperatures below freezing,
but we do not recommend operating the Animated
Airblown®if temperatures drop below 14° F (-10° C).
9. What if it is raining or snowing? Will this affect my
Animated Airblown®?
Operation of your Animated Airblown®during light
weather conditions, such as a gentle rain or snowfall is
recommended. However, operation of your Animated
Airblown®during extreme weather conditions is not
recommended, as your item may become damaged
or inundated with moisture. Do not store the Animated
Airblown®when it is wet.
10. What if water has soaked my unit while unplugged?
Move the unit to a dry location and plug in the unit. The
fan will dry the Animated Airblown®.
11. My Animated Airblown® has been deated and it is
covered with snow. Can I simply re-inate it?
If your Animated Airblown®is covered in a light dusting
of snow, simple re-ination should not harm the unit.
However, if the deated unit has been subjected to
a large amount of snow and/or ice, do NOT attempt
to re-inate. Rather, carefully remove the item from
the extreme condition (i.e. bring it indoors) and allow
the unit to thaw before re-inating. This helps prevent
cracks and/or tears in the materials.
12. What if it’s raining or snowing? Will this affect my
Animated Airblown®?
Operation of your Animated Airblown®during light
weather conditions, such as a gentle rain or light
snowfall is ne. However, operation of your Animated
Airblown®during extreme weather conditions such as
heavy snow, rain or windstorms is not recommended
as it may become over-weighted and damage the
unit.
13. I have stored my Airblown® Inatable for several
months and now the motor does not work?
Sometimes the air intake may be blocked by loose
grass/leaves or other particles. Gently shake, knock
or tap the motor and see if it will operate again.

Assembly Instructions
Package Contents
Ensure the four clips on the bottom
of the fabric of the inatable (A) are
attached to the plastic legs on the
base of the intlatable.
Ensure that the air intake on the
inatable (A) unit is clear of fabric and
other obstructions and that the zipper
is fully closed. Some inatables have
more than one zipper.
Turn the inatable (A) upright and insert
four base stakes (B) through the holes
of the plastic legs into the ground.
Plug in the inatable (A) into an outlet
or other power source to inate.
Once fully inated, clip the nylon tethers
(C) to each of the attached nylon loops
on the side of the inatable (A).
Drive the stakes (D) into ground at a
45-degree angle.
AB
1
For maximum stability bring tether down
to a 45-degree angle from the inatable
as shown in the illustration. In order to
achieve this you may need to wrap the
excess tether around the top of the stake.
23
4 5
78
A
A
A
A
B
C
A
D
45°
DE
C
x1 x4 x4 x4 x1
Visit WWW.GEMMY.COM for more information.
©2021 GEMMY INDUSTRIES CORP.
117 WRANGLER DRIVE. SUITE 100
COPPELL, TX 75019 U.S.A.
1 [phone]
MADE IN CHINA / PRINTED IN CHINA
Using the loop at the end of the tether
(C), fasten the tehters to the tether
stakes(D).
Do’s and Don’ts
1. Do check your inatable daily and adjust
to stand up straight.
2. Do not attempt to operate your inatable
in unusually strong winds.(see caution)
3. Do not unplug by pulling on cord.
For faster deation, unzip zipper after
unplugging plug.
6
9
D
C