Genie Aladdin Connect User manual

1. As long as the solid blue light is on the DCM this step has been completed.
*NOTE: The DPS sensor included with this kit is already programmed to the DCM from the factory.
2. If no blue light is glowing solid on the DCM, hold down one of the three buttons on the DCM until the
conrmation tone starts, and the device begins blinking blue.
3. While the DCM is blinking blue, hold down the button on the DPS until it begins blinking.
Conrm Door Position Sensor (DPS):
Set up of DPS is completed. No further
programming of this step is required.
*
B
E
E
P
2
34
1

5
4. Once it begins blinking the blue blinking light on the DCM will go out, then it will go out on the DPS.
5. After a few moments, the DCM light will come back on solid conrming the blue tooth signal has been
reconnected.
6. Once completed, select NEXT button the app to continue with setting up your Aladdin Connect™ unit.
© Copyright 2016 The Genie Company. All rights reserved
Which button will control your Door?
Press and hold the corresponding button on
the front of your Door Control Module until
the BLUE light begins to ash.
BACK I NEXT
6
For assistance, contact Aladdin Connect™ Customer Service at: 1-866-599-4995
or visit: www.geniecompany.com/aladdinconnect/installationvideo