Gevi GECME003D-U User manual

COFFEE MAKER
INSTRUCTION MANUAL
GECME003D-U

IMPORTANT SAFEGUARDS
Dear Gevi customer
Gevi have focused on creating perfect home appliance
for our customer. In the past years, it took us time, lots
of research and many prototypes to achieve our goal.
We would like to give you a different using experience.
Thanks for purchasing our Gevi products, you could
search from our official website, to learn more products
information.
1. Read all instructions.
2. Before using check that the voltage of wall outlet corresponds
to rated voltage marked on the rating plate.
3. This appliance has been incorporated with a grounded plug.
Please ensure the wall outlet in your house is well earthed.
4. To protect against fire, electric shock and injury to persons do
not immerse cord, plug, in water or other liquid.
5. Remove plug from wall outlet before cleaning and when not
in use. Allow appliance cool down completely before taking
off, attaching components or before cleaning.
6. Do not operate any appliance with a damaged cord or plug
or after the appliance malfunctions, or is dropped or
damaged in any manner. Return appliance to the nearest
authorized service facility for examination, repair or electrical
or mechanical adjustment.
7. The use of accessory attachments not recommended by the
appliance manufacturer may result in fire, electric shock
or injury to persons.
8. Place appliance on flat surface or table, do not hang power
cord over the edge of table or counter.
Before using the electrical appliance, the following basic
precautions should always be followed including the following:

9. Ensure the power cord do not touch hot surface of appliance.
10. Do not place the coffee maker on hot surface or beside fire in
order to avoid to be damaged.
11. To disconnect, turn any control to “off,” then remove plug from
wall outlet. Always hold the plug. But never pull the cord.
12. Do not use appliance for other than intended use and place
it in a dry environment.
13. Close supervision is necessary when your appliance is being
used by or near children.
14. Be careful not to get burned by the steam.
15. Do not touch the hot surface of appliance (such as steam wand,
and the steel mesh just boiling). Use handle or knobs.
16. Do not let the coffee maker operate without water.
17. Scalding may occur if the water tank is removed during the
brewing cycles.
18. Do not remove the metal funnel when appliance in brewing
coffee or when steam and hot water escape from metal funnel
and ensure to release the pressure in water tank before
removing metal funnel.
19. Connect plug to wall outlet before using and turn any switch
off before plug is removed from wall outlet.
20. Relief pressure through steam wand before removing tank
cover or metal funnel.
21. This appliance is not intended for used by persons (including
children) with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning
use of the appliances by a person responsible for their safety.
22. Children should be supervised to ensure that they do not
play with the appliance.
23. This appliance is intended to be used in household and
similar applications such as:
‒ staff kitchen areas in shops, offices and other working
environments;
‒ farm houses;
‒ bed and breakfast type environments.
24. Do not use outdoors.
25. Do not place on or near a hot gas or electric burner, or in
a heated oven.
26. Save these instructions

KNOW YOUR COFFEE MAKER
(Product may be subject to change without prior notice)
BEFORE THE FIRST USE
To ensure the first cup of coffee tastes excellent, you should
rinse the coffee maker with water as follows:
1. Pour water into water tank, the water level should not
exceed the “MAX” mark in the tank. Then close the water
tank cover.
NOTE: the appliance is supplied with a detachable tank for easy
cleaning, you can fill the tank with water firstly, and then put
the tank into the appliance.
2. Set steel mesh into metal funnel (no coffee in steel mesh),
make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into the appliance from
the “INSERT” position, and you can fix them into coffee
maker firmly by turning it anticlockwise until it is at the
“LOCK” position.
3. Place an espresso cup (your cup) on removable cup shelf.
Make sure the operation knob is on the “O” position.
NOTE: the appliance is not equipped with jug, please use your
jug or coffee cup.
4. Connect to power source, press the power switch to “I”
position to power on the unit. The coffee indicator will
flashing blue. The appliance will start heating.
5. When the indicator becomes solid, it shows the
pre-heating is finished. Turn the operation knob to the
“ ” position. The water will flow out.
6. After about one minute, turn the operation knob to the
“O” position to stop brewing, you can pour the water in
container out then clean them thoroughly, now you can
start brewing.
NOTE: There may be noise when pumping the water on the
first time, it is normal, the appliance is releasing the air in the
appliance. After about 20s, the noise will disappear.

PREHEATING MAKING ESPRESSO
To make a cup of good hot Espresso coffee, we recommend
you shall preheat the appliance before making coffee, including
the funnel, steel mesh and cup, so that the coffee flavour can
not be influenced by the cold parts.
1. Remove the detachable tank and open the tank cover to fill
it with desired water, the water level should not exceed
the “MAX” mark in the tank. Then place the tank into the
appliance properly.
2. Set steel mesh into metal funnel (without coffee powder),
make sure the tube on the funnel aligns with groove in the
appliance, then insert the funnel into the appliance from
the “INSERT” position, and you can fix them into coffee
maker firmly by turning it anticlockwise until it is at the
“LOCK” position.
3. Place an espresso cup (your cup) on removable cup shelf.
4. Then connect the appliance to power source. Make sure
the operation knob is on the “O” position.
5. Press down the power switch to “I” position to power on
the unit. The coffee indicator will flashing blue. The appliance
will start heating.
6. When the indicator become solid, it shows the pre-heating
is finished.
1. Remove the metal funnel by turning it in clockwise, set
steel mesh into metal funnel. Add coffee powder to steel
mesh with measuring spoon, a spoon of coffee powder
can make about a cup of top-grade coffee, then press the
ground coffee powder tightly with the tamper.
2. Then insert the funnel into the appliance from the
“INSERT” position and release the press bar, and you can
fix them into coffee maker firmly by turning it
anticlockwise until it is at the “LOCK” position.
3. At the time, the coffee indicator is illuminated blue, you
can turn the operation knob to “ ” position, the hot
water will flow out, you can use it for cleaning or heating
your cup.
4. Turn the operation knob to the “ ” position, the coffee
indicator will be illuminated blue. The coffee will flow out.
5. You should turn the operation knob to the “O” position
when desired coffee is obtained or the colour of coffee
changes weak obviously, then press the power switch to
“O” position to power off the unit, the power indicator
will extinguish and the coffee maker stops working, your
coffee is ready now.
WARNING: Do not leave the coffee maker unattended during

MAKING CAPPUCCINO
making the coffee, as you need operate manually sometimes!
6. After finishing making the coffee, you can take the metal
funnel out by turning it clockwise, then pour the coffee
residue out with the steel mesh pressed by press bar.
7. Let them cool down completely, then rinse under running
water.
You get a cup of cappuccino when you top up a cup of espresso
with frothing milk.
Note: during making steam, the metal funnel must be assembled
in position.
Method:
1. Prepare espresso first with container big enough according
to the part “MAKE ESPRESSO COFFEE”, make sure that the
operation knob is on the “O” position.
2. Press the steam switch, the steam indicator will flashing white.
Fill a jug with about 100 grams of milk for each cappuccino to
be prepared, you are recommended to use whole milk at
refrigerator temperature (not hot).
NOTE: In choosing the size of jug, it is recommended the diameter
is not less than 70±5mm, and bear in mind that the milk increases
in volume by 2 times, make sure the height of jug is enough.
3. Insert the froth device into the milk about two centimetres,
then turn the operation knob to the “ ” position, the
steam indicator will be illuminated white. The steam will
come out from the steam outlet. Froth milk in the way
moving vessel round from up to down.
4. When the required purpose is reached, you can turn the
operation knob to the “O” position.
NOTE: Clean steam outlet with wet sponge immediately after
steam stops generating, but care not to hurt!
5. Pour the frothed milk into the espresso prepared, now the
cappuccino is ready. Sweeten to taste and if desired, sprinkle
the froth with a little cocoa powder.
6. Press the power switch “O” position to cut off the power
source.
NOTE: after making steam, if you want to brew coffee
immediately, you should turn the operation knob to “ ”
position, pump water to cool down. Before next operation
cycle, unit must have a rest for at least 2 minutes.

PRODUCING STEAM TO HEAT LIQUIDS OR BEVERAGE SPECIAL FUNCTIONS
The steam wand can be used to make hot beverages like
drinking chocolate, water or tea.
Method:
1. Remove the detachable tank and fill it with desired water,
the water level should not exceed the “MAX” mark in the
tank. Then place the tank into the appliance properly.
2. Then connect the appliance to power source. Press the
power switch to “I” position to power on the unit, the coffee
indicator will flashing blue.
3. Press steam switch, the unit will enter steam function, the
steam indicator will flashing white. The appliance will start
heating. When the indicator become solid, it shows the
pre-heating is finished.
4. Dip the steam wand without froth device sleeve into the
liquid to be heated or the intended froth milk. Turn the
operation knob to the “ ” position.
5. When the required temperature is reached, you can turn the
operation knob to the “O” position.
6. Press the power switch to “O” position to cut off the power
source.
1. When the appliance is in steam function, if you turn the
operation knob to“ ” position, both of the coffee
indicator and steam indicator will flashing for alarming;
2. When finishing producing steam, the temperature of
the boiler is very high, if you press the coffee switch at
this time, the coffee indicator will fast flashing, it indicates
the appliance need cooling;
3. The longest time for brewing coffee is 90s, if you forget
turning the operation knob to “O” position after finishing
making coffee, the appliance will stop working after 90s,
and both of the coffee indicator and steam indicator will
flashing for alarming;
4. If there is no any operation within 25 minutes, the unit
will power off automatically, you should press the power
switch to “O” position then press it to “I” position to
restart the appliance.

1. Cut off power source and let the coffee maker cool down
completely before cleaning.
2. Clean housing of coffee maker with moisture-proof sponge
often and clean water tank, drip tray and removable shelf
regularly then dry them.
NOTE: Do not clean with alcohol or solvent cleanser. Never
immerse the housing in water for cleaning.
3. Detach the metal funnel by turning it clockwise, get rid of
coffee residue inside, then you can clean it with cleanser,
but at last you must rinse with clear water.
4. Clean all the attachments in the water and dry thoroughly.
stores) instead of the descaler (the one hundred parts of water
and three parts of citric acid).
3. According to the program of pre-heating, put the metal funnel
(no coffee powder in it) and carafe (jug) in place. Brewing water
per “ PRE-HEATING”.
4. Press the power switch to “I” position to power on the unit.
The coffee indicator will flashing blue. The appliance will start
heating.
5. Waiting for a moment, until the indicator becomes solid, it
shows the pre-heating is finished.
6. Turn the operation knob to the “ ” position and make
two cups coffee (about 2Oz). Then turn it to the “O” position.
7. Press the steam switch, the indicator will flashing white,
waiting for until the indicator becomes solid. Turn the
operation knob to the “ ”position and make steam for
2mins, then turn the operation knob to “O” position to stop
making steam. Press the power switch to “O” position to
stop the unit immediately, make the descaler deposit in the
unit at least 15 minutes.
8. Restart the unit and repeat the steps of 4-7 at least 3 times.
9. Then brewing coffee (no coffee powder) with tap water in the
MAX level, repeat the steps of 4-7 for 3 times (it is not
necessary to wait for 15 minutes in step of 7), then brewing
until no water is left in the tank.
1. To make sure your coffee maker operating efficiently,
internal piping is cleanly and the peak flavor of coffee,
you should clean away the mineral deposits left every
2-3 months.
2. Fill the tank with water and descaler to the MAX level ( the
scale of water and descaler is 4:1, the detail refers to the
instruction of descaler. Please use “household descaler”,
you can use the citric acid (obtainable from chemist’s or drug
CLEANING AND MAINTENANCE
CLEANING MINERAL DEPOSITS

TROUBLE SHOOTING
CORRECT DISPOSAL OF THIS PRODUCT
Symptom
Water leaks
from the
bottom of
coffee maker.
Acid (vinegar)
taste exists in
Espresso
coffee.
The coffee
maker cannot
work any more.
The steam
cannot froth.
There is much water
in the drip tray.
The coffee maker
is malfunction.
No clean correctly after
cleaning mineral deposits.
The coffee powder is
stored in a hot, wet
place for a long time.
The coffee powder
turns bad.
The power outlet is not
plugged well.
The ready indicator is
not illuminated.
The container is too big
or the shape is not fit.
You have used skimmed
milk
Please clean the drip tray.
Please contact with the
authorized service facility
for repairing.
Clean coffee maker per the
content in “before the
first use” for several times.
Please use fresh coffee
powder, or store unused
coffee powder in a cool,
dry place. After opening a
package of coffee powder,
reseal it tightly and store it
in a refrigerator
to maintain its freshness.
Plug the power cord into a
wall outlet correctly, if the
appliance still does not work,
please contact with the
authorized service facility
for repairing.
Only after the ready indicator
is illuminated, the steam can
be used to froth.
Use high and narrow cup.
Use whole milk or
half-skimmed milk
Cause Corrections
Do not take apart the appliance by yourself if the cause of failure
is not found, you had better contact certified serving center.
This marking indicates that this productshould not be
disposed with other household wastes throughout the
EU. To prevent possible harm to the environment or
human health from uncontrolled waste disposal, recycle
it responsibly to promote the sustainable reuse of
material resources. To return your used device, please
use the return and collection systems or contact the
retailer where the product was purchased. They can
take this product for environmental safe recycling.