Giesemann MINOX GIESEMANN User manual

CE Declaration of Conformity
The company
Giesemann Lichttechnik & Aquaristik GmbH
Bürdestraße 14 – 41334 Nettetal – Germany
declare under our sole responsibility that the products:
AURORA V8
to which this declaration relates are in conformity with the technical requirements of
the following European Community directives & standards or other normative documents
- 98/37/EC / - EEC 89/336 - EEC 73/23 AND RELATED AMENDMENTS AND
ADDITIONS (B.T.)
The following technical standards and specifications have been observed:
Safety: EN 60335-1 / EN 60335-2- 55 AND
RELATED AMENDMENTS / EN 292-1-2 / CEI 61-50
EMC directive: EN 50081-1 / EN 50081-2 and the following amendments / EN 5008
16.05.2021, Nettetal - Germany

If you want to suspend your luminaire, use the optionally available F suspension system.
The bracket is mounted on the rear side of the luminaire housing with the screws supplied
and the cable system is attached from above.
Suspension system
-------------------------------
-------------------------------
Attach the two wires on the top of your fixture by screwing the screws into the nuts
on the top rail. Check the tightness of the cable holder. Install the ceiling mounting with
suitable screws and wall plugs, making sure that the brickwork/ceiling on site can
offer sufficient support. If necessary, special fastening systems, such as Hollow wall
anchors, screws, etc may be necessary. If uncertain, please consult with a specialist company.
Now run the steel cord through the bore of screw. Screw into the ceiling mount
Insert the loose end of the steel cable into the top opening of the cable holder hole and
push through until the end exits through the side hole. Since your light is equipped with
continuously variable height adjustment, it can be raised or lowered easily by applying pressure
to the nozzle of the spring lock mechanism. For safety reasons, always support the lamp when
it is being adjusted. When the light unit is gently lowered again with the nozzle released the
cable will automatically lock in place. Always aim to set your light unit level with the aquarium.