4. EARLY WARNING FEATURE
•Modes 1,3,8 have an “early waring” whereby one of the LEDs illuminates before the end of the
countdown. To activate this feature, press all 3 buttons simultaneously and wait for the time to flash.
(should take 5 seconds)
•When flashing, program the desired early warning time. (if setting seconds then you will hold down the
front button and the UP button simultaneously)
•When you have the desired “early warning” time, let the buttons go and wait for 3 seconds. The display
will flash to lets you know you have exited the “early warning” setting mode.
•Time is now ready to set the
cycle time, or run a cycle.
5. REPEAT CYCLE
•Mode 11 you set the interval
time by holding all 3 buttons
simultaneously.
6. OTHER NOTES
•Settings will be kept in
memory when power turned
off.
•Pressing both blue buttons
resets display to zero time.
•Holding down blue buttons
for a few seconds advances
the time quickly.
•Relay output is set to N.O.
Can be changed to N.C. by
landing the “HOT” wire on
the N.C. terminal. (see
diagram)
