User Manual
GL-SP15 Series
1. The “Warranty Period” is two (2) years. We will warrant free repair or replacement services if
the product fails or becomes defective during normal use within the prescribed warrantee
period. Please send back the product to our company or contact your local distributors for
further directions.
2. Do not change or tamper with any internal electric circuits or add in any wires or cables for
any reason.
3. Do not change the mechanical design, circuit specifications, or components; do not add any
other devices as this may cause the product to short circuit or may create other unforeseen
risks.
4. Keep the lamp set in a dry environment in order to avoid any electricity leakage.
5. To avoid electrical shocks and possible malfunction, please do not insert objects of any
nature into the LED product.
6. For further information, please contact us.
CAUTION
Best Position
CAUTION
CLASS 2 LED LIGHT
DO NOT STARE INTO THE BEAM
GL-SP15
100V-240V~ 50-60Hz
Thanks for your choice of LED
SP15 series products. Please
ensure that you install and use the
product according to the below
directions to enable the correct
implementation and normal
functioning of the LED product.
Should you not follow these directions,
you will not be compensated in
accordance with the warrantee. We will not
take any responsibility from the improper
use and implementation of the product, and
for any associated damage caused by such
irresponsible and negligent actions.
1. Before installation,
please turn off the
power switch for the
existing bulb.
2. Please make sure that the specifications
of the power connector and the output
voltage are compatible to the LED
fixture used.
• Pick a vantage point based on the directions of human and car traffic
• Install the sensor at a location within 10 ~ 15 meter radius of the vantage point, 2.5 ~ 3 meter high and at an angel of adjustable
sensor is up / down 10° ~ 30° (best at 90 degree)
• Make sure the sensor is firmly screwed
Worst sensing effects
(Straightline moving forward)
Insufficent range due to low sensing angle
Short sensing range and prone to false detections
due to high sensing angle
4. Screw the LED fixture tight onto a wall
or a stand and adjust the angle in
accordance with individual needs.
5. Please plug the unit into an appropriate
power socket and turn the power on. If the
lamp does not work, please repeat steps
1-4 until it does work.
Installation process
Please get professional installation personnel to set up the fixture.
Indicators on the bottom of
the sensors
1. SENS: The intensity of sensing. + indicates strong sensing.
- indicates weak sensing.
2. LUX: The brightness of the environment. Moon mark (3lux)
indicates night sensing; effective when human
entering the sensing area in low illuminations. Please
avoid strong light resource because it may lead
sensor to false detections. Sun Mark (5lux) indicates
24-hour sensing regardless day or night. It is effective
whenever human entering the sensing area.
3. TIME: The light up time of sensing. From 7 seconds to 12
minutes.
