Glasdon EcoNexus Duo Manual

EcoNexus Duo
1
Operator Instruction Leaet
OPENING THE ECONEXUS SECURING SACK IN POSITION
EMPTYING THE ECONEXUS
ATTACHING A SIGN KIT
IMPORTANT NOTE: ENSURE THAT ALL RELEVANT PERSONNEL READ THESE INSTRUCTIONS PRIOR TO USE
1.
4.
7.
2.
5.
8.
3.
6.
9.
Using the nger lips, lift the lid up-
wards until it stands upright.
Lower lid to replace, ensuring sacks are
neatly secured underneath.
Align the 2 holes with the threaded holes in the
metal brackets attached to the bin rear. Notes:
Do not place sign holder into cutout slots on bin
rim. Sign can only be tted at the rear of the bin.
To install sacks, rstly insert into the central slots
then stretch over the outer rim of bin.
Central Slot
Remove Lid.
Arrange the included xtures as fol-
lows; Screw, Washer, Locking Washer.
For 50/50 use 2 x 500x1050mm sacks;
For 70/30 use 1 x 500x1050mm & 1 x
610x1720mm sacks.
Release each sack individually from the bin
rim and lift upwards out of the bin body.
Using an allen key, fasten the sign
holder to the bin securely.

EcoNexus Duo
2
10.
13.
11.
14.
12.
Place A4 sign behind clear polycar-
bonate sheet and slide into sign
carrier.
Push both socket caps into the
moulded recesses opposite wheels.
From kit provided, place 1 screw
through a wheel.
The lugs locate in the holes along the
bottom of the carrier to secure the
sign.
Using lip on body as a handle, tilt bin
onto wheels to manoeuvre.
With bin body upside down, click screw
and wheel into moulded slot. Repeat with
second wheel.
ATTACHING WHEELSINSERTING A4 SIGN