Glatz Fortino User manual

Sunshade
Fortino / Fortero
Service Manual
Fortino / Fortero

Sunshade
Fortino / Fortero
G latz AG 10.01.28_Servicemanual Fortino_Fortero_en
Pfad:K:\Marketing&Verkauf\Drucksachen\Service Manual\Fortino Fortero\Word Dateien\10.01.28_Servicemanual Fortino_Fortero_en.doc
Created: Dino Aeschbacher/13.01.2010 Released: Sergio Malacarne/19.01.2010
This manual describes the following procedures:
1. Changing the top 3
2. Changing cover 3
3. Changing the rod, tension lever, crown, slide 4-5
4. Changing the rod extension 6
5. Changing the lower pole 6
We reserve the right to make technical modifications.
© Glatz AG 01/2010
GLATZ AG . Neuhofstrasse 12 . 8500 Frauenfeld . Switzerland . www.glatz.ch

Sunshade
Fortino / Fortero
G latz AG 10.01.28_Servicemanual Fortino_Fortero_en 3
Pfad:K:\Marketing&Verkauf\Drucksachen\Service Manual\Fortino Fortero\Word Dateien\10.01.28_Servicemanual Fortino_Fortero_en.doc
Created: Dino Aeschbacher/13.01.2010 Released: Sergio Malacarne/19.01.2010
3
Preparation : Lay out a clean cloth or sheet on which to place the sunshade
Tools: Cross-head screwdriver or battery screwdriver / pin spanner (3mm)
1. Changing the top
Proceed as follows with the sunshade erect or on its side:
•Unscrew the top and screw on new top
2. Changing the cover
•Unscrew the top and loosen the screws on rod ends. Remove the cover.

Sunshade
Fortino / Fortero
G latz AG 10.01.28_Servicemanual Fortino_Fortero_en 4
Pfad:K:\Marketing&Verkauf\Drucksachen\Service Manual\Fortino Fortero\Word Dateien\10.01.28_Servicemanual Fortino_Fortero_en.doc
Created: Dino Aeschbacher/13.01.2010 Released: Sergio Malacarne/19.01.2010
3. Changing the rod, tension lever, crown, slide
Secure the rods with the belt.
To remove the crown cover unscrew the crown-screws one by one. Then you will be
able to pull out the rods or tension lever. Hang in the new rods or tension lever.
crown screws one by one

Sunshade
Fortino / Fortero
G latz AG 10.01.28_Servicemanual Fortino_Fortero_en 5
Pfad:K:\Marketing&Verkauf\Drucksachen\Service Manual\Fortino Fortero\Word Dateien\10.01.28_Servicemanual Fortino_Fortero_en.doc
Created: Dino Aeschbacher/13.01.2010 Released: Sergio Malacarne/19.01.2010
•Auxiliary crown:
Loosen the screws on the cover and pull out the rod; pull out the auxiliary crown with
the upper section of pole.
•Slide:
Loosen the screws on the slide and remove the rod.

Sunshade
Fortino / Fortero
G latz AG 10.01.28_Servicemanual Fortino_Fortero_en 6
Pfad:K:\Marketing&Verkauf\Drucksachen\Service Manual\Fortino Fortero\Word Dateien\10.01.28_Servicemanual Fortino_Fortero_en.doc
Created: Dino Aeschbacher/13.01.2010 Released: Sergio Malacarne/19.01.2010
4. Changing the rod extension
Pull out the extension and insert a new extension into the rod.
5. Changing the lower pole
•You must be careful when fitting together the two sections of pole. The upper
section has an internal tongue. This should be positioned so that it fits into the
groove in the lower pole.
•It is correctly positioned if the hole in the upper pole is flush with the hole in the
neck of the lower pole.
Screw the two sections of pole together.