Global Terina User manual

Effective June 2018
INSTALLATION GUIDE

TERINA INSTALLATION GUIDE
2 globalfurnituregroup.com
•Pageglobalcontract.com 74
GLOBALContract • Fall 2017
INSTALLATION GUIDELINES
Flip Top Tables
Legs
Safety Glasses
Allenkeys Phillips Bit Spacer Block
3 9/16” x 1 7/8” (included)
Drill Measuring Tape Wrench
Required Tools
Pre Assembled Components
1. Connect the leg to cross beam.
Legs Cable Release/Support BeamsCross Beam
2. Snap on black plastic cover to
conceal connection.
3. Snap support block into channel
on top of cross beam.
Pivot Bracket
4. Remove end cap from the end
of the support beam.
5. Ensure pivot bracket is installed 3 9/16” from the end of the extrusion. Replace the end cap.
6. Connect the base to the support beam.
Insure that black nylon washers (A) are installed between the pivot bracket and the assembly.
3 9/16”
A
BC
A

TERINA INSTALLATION GUIDE TERINA INSTALLATION GUIDE
globalfurnituregroup.com 3
Page • globalcontract.com75
• Fall 2017
GLOBALContract
Flip top table top
7. Connect the beams to the table top using the pilot
holes provided.
8. Position cable release mechanism in the center of the table 1” from the user edge
and screw into the underside of the top.
9. Secure the cables to underside of the top with the provided brackets (4).
1”
INSTALLATION GUIDELINES

TERINA INSTALLATION GUIDE
4 globalfurnituregroup.com
•Pageglobalcontract.com 76
GLOBALContract • Fall 2017
Optional Modesty Panel
1. Remove end cap and insert bolt into the inside slot. Use the rubber mallet to
secure the end cap in original position.
2. Use the guide to position the bolt with washer and nut 1 7/8” from the end.
Tighten nut in place.
3. Connect the modesty bracket as shown.
Insure that nylon washers (A) are installed on either side of the modesty
bracket.
1 7/8”
A
INSTALLATION GUIDELINES

TERINA INSTALLATION GUIDE TERINA INSTALLATION GUIDE
globalfurnituregroup.com 5
Page • globalcontract.com77
• Fall 2017
GLOBALContract
Flip top tables
4. Unbolt the pre-installed foot from it’s column. Insert the slotted bolt in the channel.
Reconnect the foot and column. Tighten the bolt with washer and nut 4 7/8”
from the bottom at the foot connection.
5. Connect the modesty panel bracket as shown.
Insure that nylon washers (A) are installed on either side
of the modesty bracket.
6. Attach modesty panel. Using guide block position panel 1 7/8”
below support beam and screw in place.
4 7/8”
1 7/8”
A
INSTALLATION GUIDELINES