GOAL ZERO NOMAD 200 User manual

1

GET TO KNOW YOUR GEAR
Plug the APP connector into the input port on the Goal Zero Yeti. You’ll get the best solar charging
experience if you continue to reposition the solar panel throughout the day. Make sure to reference the
specs of what you’re plugging the Nomad 200 into. On Yeti Portable Power Stations, you’ll be checking the
input specs.
Kickstand
2.4A USB-A Output Port
Anderson Powerpole
Output Connector (6 FT.)
HOW TO CONNECT
Goal ZeroYeti
Portable Power Station
Nomad 200
Solar Panel
Phones, Tablets,
and Laptops
HOW IT WORKS

To chain multiple Nomad 200 Solar Panels together, you’ll need to purchase the 4x Anderson Combiner Cable
(SKU 98061) from Goal Zero.
Charge Times
Goal Zero Yeti 1000X 6-12 hrs
Goal Zero Yeti 1500X 9-18 hrs
Goal Zero Yeti 3000X 18-36 hrs
Solar Panel
Rated Power 200W
Open Circuit Voltage Voc 23.0V
Cell Type Monocrystalline
Ports
Anderson Powerpole 14-23V, up to 14A (200W max)
USB-A (output) 5V, 2.4A(12W max)
General
Weight 22 lbs (10.0 kg)
Dimensions (unfolded) 28.2 x 100.7 x 1.0 in (71.6 x 255.8 x 2.5 cm)
Dimensions (folded) 28.2 x 22.3 x 2.0 in (71.6 x 56.6 x 5.0 cm)
Certs
Warranty 12 months
Be sure to activate your warranty at goalzero.com/warranty
TECHNICAL SPECIFCATIONS
HOW TO CHAIN

GOAL ZERO HEADQUARTERS
675 West 14600 South
Bluffdale, UT 84065
1-888-794-6250
Designed in the U.S.A.
Made in China
Nomad is a trademark of Goal Zero.
JG071720V2
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
—Consult the dealer or an experienced radio/TVtechnician for help.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that
may cause undesired operation.