Goldair GCT200 User manual

For model: GCT200
CERAMIC TOWER HEATER
OPERATING INSTRUCTIONS

1. Use only the voltage specified on the rating
plate of the appliance.
2. Keep all objects at least 1 metre from the
front, sides and rear of the appliance. Do not
place appliance close to radiant heat source.
3. Do not operate in areas where petrol, paint or
other flammable liquids are used or stored.
4. Do not insert or allow foreign objects to enter
any ventilation or exhaust opening, as this
may cause an electric shock, fire or damage
to the appliance.
5. Do not operate this appliance with a
damaged cord, plug or after the appliance
malfunctions or has been dropped or
damaged in any manner. Return to a
qualified electrical person for examination,
electrical service or repair.
6. This appliance is intended for household use
only and not for commercial or industrial use.
7. Use this appliance only as described in this
manual. Any other use is not recommended
by the manufacturer and may cause fire,
electrical shock or injury.
8. The common cause of overheating is
deposits of dust or fluff in the appliance.
Ensure these deposits are removed regularly
by unplugging the appliance and vacuum
cleaning the air vents and grills.
9. Do not use abrasive cleaning products on
this appliance. Clean with a damp cloth (not
wet) rinsed in hot soapy water only. Always
removed plug from the mains supply before
cleaning.
10.Do not connect the appliance to mains
voltage until completely assembled and
adjusted.
11.Switch off and use handles provided when
moving.
12.Do not operate with cord set coiled up as a
heat build up is likely, which could be
sufficient to become a hazard.
13.The use of an extension cord with this
appliance is not recommended.
14. Do not remove plug from power socket until the
appliance has been switched off.
15. Do not remove plug from power socket by
pulling cord –always grip plug.
16. Always unplug appliance when not in use.
17. Do not twist, kink or wrap the cord around the
appliance, as this may cause the insulation to
weaken and split. Always ensure that all cord
has been removed from any cord storage area
and is unrolled before use.
18. This appliance is not intended for use by young
children or infirm persons unless they have been
adequately supervised by a responsible person
to ensure that they can use the appliance safely.
19. Do not use this appliance in the immediate
surrounds of a bath, a shower, or a swimming
pool or other liquids. The appliance must not be
immersed in any liquids.
20. When the appliance has been unpacked, check
if for transport damage and ensure all parts have
been delivered. If parts are missing or the
appliance has been damaged, contact the
Goldair Customer Services Team. (refer to
details on back page)
21. If your appliance does not work, or is not
working properly, contact the place of purchase
or the Goldair Customer Services Team. (refer
to details on back page). Repair work on the
appliance by unqualified persons can cause
serious risk to the user.
22. There are no user serviceable parts installed in
the unit.
23. Do not put your fingers or other articles into or
near the air inlet or outlet. Do not sit on the unit.
24. Do not place the unit in wardrobes or other
enclosed spaces as this may cause fire hazards.
25. This unit is not supposed to be used in or around
locations where foodstuffs, works of art or
delicate articles of science, etc are stored.
26. Indoor use only.
27. Children should be supervised to ensure that
they do not play with the appliance.
WARNINGSAND SAFEGUARDS

OVERVIEW OF GOLDAIR FAN HEATER
Your Goldair Ceramic Tower Heater is designed to provide direct personal heating. The heater is equipped
with various heat settings and a fan option to ensure your precise heating needs are met.
OPERATING YOUR HEATER
Always choose a safe location for the heater, keeping in mind the safety precautions outlined. Ensure all
packaging has been removed from the unit before use. This appliance requires no installation, it should be
used solely as a portable appliance.
CONTROL PANEL
The control switch positions are:
Control Panel
1 –Timer 4 –Heat/Fan Setting
2 –Oscillate 5 –Decrease Temp
3 –On/Off 6 –Increase Temp
1 2 3 4 5 6

CONTROL PANEL (continued)
The heater must be operated by the controls located on the heater.
The heater must be placed on a flat floor or the tip switch will shut it off automatically.
1. Timer Button –The timer function allows you to set the length of operation from 1-8 hours. On any heat
or fan setting press this button to set a desired time for the unit to operate before turning off automatically
(i.e. if you would like the heater to run for 4 hours and then turn off press the Timer Button until a 4 is
displayed on the control panel and the unit will run for 4 hours then turn off)
2. Oscillate Button –This button turns the heater oscillation function on and off.
3. On/Off Button –This button turns the heater on and off.
4. Heat/Fan Setting Button –This button sets the desired heat/fan setting. Press the button once for low
heat, twice for high heat, three times for auto mode (the heater will operate at low or high heat in order to
reach a set temperature on the display). Please note that when the heater is turned on it will
automatically be on the fan only mode until changed.
5-6. Decrease and Increase Temp Buttons (UP and DOWN) –These two buttons sets the temperature
desired when the unit is functioning on the temperature controlled auto mode (see Heat Mode button). To
increase the desired set temperature press the “+” button and to decrease the desired set temperature press
the “-” button.
How the set temperature is maintained:
- If the room temperature is higher than the set temperature, the heater switches itself off.
- If the room temperature is lower than the set temperature, the heater automatically switches itself back
on again
WARNING：DO NOT PLACE THE HEATER UNDER A POWER SOCKET
NEVER LOCATE THE HEATER IN A BATHROOM OR OTHER WET/DAMP LOCATIONS
MAINTENANCE
WARNING: ALWAYS UNPLUG THE CORD BEFORE MOVING OR SERVICING.
DO NOT IMMERSE HEATER IN WATER.
CLEANING: Clean the heater at least once a month, more often if dirty or dusty.
Clean the heater grill with the vacuum brush attachment on your vacuum cleaner. This will remove lint and
dirt from the inside of the heater.
Do not attempt to take apart the heater.
Do not remove grill guard or allow heater to be operated without grill guard in place.
Clean the body of the heater with a soft cloth. (NEVER USE ALCOHOL OR SOLVENTS.)
STORAGE: Store the heater with these instructions in the original carton in a cool, dry place.

IMPORTANT! ~ NEVER COVER THIS HEATER!
-This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety.
- Children should be supervised to ensure that they do not play with the appliance.
- If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly
qualified persons in order to avoid a hazard.
- WARNING : In order to avoid overheating, do not cover the heater.
- Indoor use only.
-The heater must not be located immediately below a socket-outlet.
-Do not use this heater in the immediate surroundings of a bath, a shower or swimming pool.
-Do not use this heater with an external programmer, timer, separate remote-control system or any other
device that switches the heater on automatically.
ADDITIONAL SAFETY INSTRUCTIONS
SUPPORTAND TECHNICALADVICE
North Shore City, Auckland, New Zealand
Monday –Friday 8am-5pm
Phone: [phone]
Website: www.goldair.co.nz
GOLDAIR CERAMIC TOWER HEATER SPECIFICATION
Model No: GCT200
Power Supply: 230-240V, 50Hz
Power: 2000W

Your Goldair product has been inspected and tested and is guaranteed subject to the
following for a period to two years from the date of purchase against defects in
workmanship and materials. During this period, such defects will be rectified by
repair or replacement of the product purchased. Your product contains no user
serviceable components and this warranty becomes invalid if in our opinion the
product has been misused, abused, incorrectly installed, tampered with, connected
to an electrical supply not corresponding with the name plate specification, or
subjected to power surges. The warranty does not include any labour or other
associated expense that may be involved in removal or installation of the product.
Normal wear and tear is expressly excluded.
If your Goldair product fails to operate satisfactorily, please return it to the retailer
from whom it was purchased. To obtain a repair or replacement product under this
warranty, you will need to produce satisfactory evidence of date of purchase. The
completed warranty and purchase receipt must be presented with the product. The
warranty should be filled out at the time of purchase. It is in your interest to make
sure this is done.
If the product is to be replaced (cannot be repaired) then that replacement will be of
the same or similar product or accessory excluding packaging, instruction card etc.
Where a replacement product is supplied, this shall be guaranteed for the balance of
the original warranty period.
Any model that is no longer available will be replaced by a model of a value and with
such features as we consider appropriate in the circumstances. Goldair Ltd is not
responsible for freight forwarding charges, losses or damage in transit.
If service is required after the warranty period has expired, the product should be
returned to a qualified electrical technician. Service outside of the warranty period
will be at your cost.
Consumers GuaranteeAct (1993).
In accordance with the above act consumers are advised that: The manufacturer
does not undertake that repair facilities and parts are necessarily available for this
product.
If any of the provisions of the foregoing are contrary to any relevant legislation, then
that provision shall be deemed to be excluded from the warranty and the rest of the
provisions will continue to apply.
TWO YEAR WARRANTY
IMPORTANT: PLEASE RETAIN THIS WARRANTY CARD
NAME:
ADDRESS:
PURCHASED FROM:
SUBURB:
DATE OF PURCHASE:
NAME OF PRODUCT:
MODEL No: