Goldair GBT100 User manual

Models: GBT100
Heated Towel Rail Timer
Operating Instructions

Operating Instructions
Warnings & Safeguards
1. Children should be supervised to ensure they do not play with the timer.
2. This timer is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have
been given supervision or instruction concerning use of the appliance by a person
responsible for their safety.
Operation (Pre-set function)
When you first turn the heated towel rail on, this will automatically use the timer’s pre-set
function.
Pre-set function - The heated towel rail will turn on and remain on for a period of 4 hours,
followed by 8 hours off.
Programming:
You can increase the ON period in increments of 1 hour by turning the heated towel rail off
at your switch then on again within 10 seconds of first turning the rail on. Each repetition
of this on/off sequence will increase the ON period by 1 hour (maximum of up to 11
hours).
If you would like to restore the pre-set 4-hour setting, discharge all the electricity and
power in the timer by turning the heated towel rail off for 60 seconds (this will clear the
memory).
To reset the timer, turn the heated towel rail on again.
Important Notes:
•This timer must be installed by a licensed electrician in accordance with the Australia /
New Zealand Wiring Rules AS/NZS 3000 or the warranty will be voided
•Do not megger test as this can damage the timer
•The timer may not be installed with towel rails fitted with self-resetting or non-self-
resetting thermal cuts or protective devices (non-self-resetting) which can be reset by
disconnection of the mains supply.
•The GBT100 timer is designed only to be used as a heated towel rail timer and should
not be used for any other purpose
•The maximum load is 1000 Watts (resistive) at 220-240V ~ 50Hz
•The timer is designed and should be installed and concealed behind the heated towel
rail’s switch in a typical wall cavity flush box.
•There are no user serviceable internal parts in this product, and should damage or
malfunction occur, please return to the manufacturer for repair or replacement
•Wiring size: 1.0-1.5mm²
•All pole disconnection must be required in fixed wiring

Mounting
Independently mounted control for flush
_mounting
Type of automatic action of a control
Type 1, Type 1.B, Type 1.S
Operating time
11 Hours
Control pollution degree
Pollution degree 2
Classification of control
Class II control
Number of automatic cycles
5000 cycles
Circuit disconnection or interruption
Micro
-disconnection
PTI
175V
Period of the electrical stress
Long period
Glow wire test temperatures
850
°C
Rated impulse voltage
4000V
Temperature for the ball pressure --
--
test
125
°C
Ambient condition
Tmin
：0°C，Tmax:55°C。
Technical Specs
Goldair –New Zealand
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[email protected]
Goldair –Australia
Monday –Friday 8am-5pm
Phone [phone]
Phone [phone]
[email protected]om.au
SUPPORT AND TECHNICAL ADVICE

Thank you for purchasing this Goldair product. Your product is warranted against faults and manufacture when
used in normal domestic use for a period of one year. In non-domestic use Goldair limits the voluntary warranty to
three months.
Goldair undertake to repair or replace this product at no charge if found to be defective due to a manufacturing
fault during the warranty period.
This warranty excludes damage caused by misuse, neglect, shipping accident, incorrect installation, or work carried
out by anyone other than a qualified electrical service technician.
PLEASE KEEP YOUR RECEIPT AS THIS WILL HELP VERIFY YOUR WARRANTY.
The benefits given to you by this warranty are in addition to other rights and remedies available to you under law in
relation to the goods or services to which this warranty relates.
In Australia, our goods come with guarantees that cannot be excluded under the Australian Consumer Law. You are
entitled to a replacement or refund for a major failure and compensation for any other reasonably foreseeable loss
or damage. You are also entitled to have the goods repaired or replaced if the goods fail to be of acceptable quality
and the failure does not amount to a major failure.
In New Zealand this warranty is additional to the conditions and guarantees of the Consumers Guarantee Act
(1993).
One Year Warranty
Goldair Two Year Warranty (IMPORTANT: Please complete and retain this warranty card)
Name
Address
Place Of Purchase Date Of Purchase
Name Of Product Model Number
Attach a copy of the purchase receipt to this warranty card
Due to continual design improvements, the product illustrated in this User Manual may differ slightly from the actual product.
Goldair –New Zealand
CDB Goldair
PO Box 100-707
N.S.M.C
Auckland
Phone [phone]
Phone [phone]
www.goldair.co.nz
Goldair –Australia
CDB Goldair Australia Pty
PO Box 574
South Morang
Victoria, 3752
Phone [phone]
Phone 1300 GOLDAIR (1300 465 324)
www.goldair.com.au

New Zealand
PO Box 100707,
North Shore Mail Centre,
Auckland, 0745
www.goldair.co.nz
Australia
PO Box 574,
South Morang,
Victoria, 3752
www.goldair.com.au