Goldfern Mobility PEDAL EXERCISER User manual

PEDAL EXERCISER
www.goldfernmobility.co.nz
ASSEMBLEY GUIDE
Parts: Step 1: Step 2:
Step 3: Step 4: Finished Assembly:
This product is already
pre-assembled with only
the tension adjustment
bolt packed separately
to reduce the overall
carton size.
After removing all the
plastic wrapping insert
the tension adjustment
bolt into the top of the
central housing and
lightly tighten.
Unfold each of the lower
leg sections and ensure
the spring release
buttons are engaged
clicked into place.
The spring release
buttons can be pressed
in to allow the lower leg
sections to be re-folded
under the central
housing.
The pedal straps have
2 sets of holes to allow
you to adjust the length
of the strap around your
foot or shoe.
When assembled your
pedal exerciser should
look like this.

PEDAL EXERCISER
www.goldfernmobility.co.nz
OPERATING GUIDE
Counter 1: Counter 2: Counter 3:
Care When Folding Limited Use Design Heat From Friction
Press the MODE / RESET
button on the multi-
function counter to turn
it on. Press it again to
select the TIME, CAL and
RPM displays.
The SCAN option will
cycle through the TIME,
CAL and RPM displays
with each one being
displayed on the screen
for a few seconds.
The multi-function
counter will stop
“counting” if you stop
turning the pedals.
After a few minutes
without any movement
it will turn itself off.
Take care when folding
the pedal exerciser and
keep fingers, feet and
legs clear of the folding
mechanism or frame.
This pedal exerciser is
designed for limited or
domestic usage and is
not designed for high or
commercial usage.
Parts of this pedal
exerciser, including the
pedal shaft near the
central housing, may
become warm or hot
during use.
SAFETY WARNINGS