Golight 2000 Manual

IMPORTANT SAFETY INFORMATION
This symbol is to alert you to important operating or
servicing instructions that appear in your instructions.
Always follow basic safety precautions when using this
product to reduce the risk of injury, fire or electric shock.
This light is for off road and utility use only. It is not
designed for road use as a driving light.
The RadioRay® complies with Part. 15 of the FCC Rules.
Operation is subject to the following two conditions: (1)
This light and remote may not cause harmful interference,
and (2) this light and remote must accept any interference
received, including interference that may cause undesired
operation.
 FCC RULE Part. 15.21 - Changes or modifications made
by the user not expressly approved by Golight, Inc. for
compliance could void the user’s authority to operate the
equipment.
For safe and efficient operation of your Golight® RadioRay®,
observe these guidelines:
Using your RadioRay® in icing conditions could damage the
gear motors.
The remote must be kept clean and dry to avoid damage to the
internal circuitry.
Your Golight® RadioRay® is a radio transmitter and receiver
operating at 433MHz. Whenever the light is on, the internally
mounted antenna sends out and receives radio frequency (RF)
energy.
• Modern electronic equipment, i.e. Personal medical devices
such as pacemakers, hearing aids, etc., are shielded from
RF energy. However, RF energy may affect some electronic
equipment.
• Vehicle electronic systems may be affected by RF energy.
Check with your vehicle manufacturer representative to
be sure that your RadioRay® will not affect the electronic
system of your vehicle.
PARTS / ACCESSORIES
Golight® RadioRay® parts and accessories may be purchased
through Golight, Inc. Visit our web store at:
http://store.golight.com or contact us at 308.278.3131 or
800.557.0098.
THREE YEAR LIMITED WARRANTY
Golight, Inc. warrants the RadioRay® against any deemed
defects that are due to workmanship for parts or faulty
materials, except halogen lamps, for three years from the date
of the original purchase. This warranty to the RadioRay® does
not cover damage resulting from unreasonable use or misuse,
unreasonable maintenance or loss, or labor costs.
Mounting the light upside down will void the warranty.
Warranty information must be filled out within 30 days of
purchase at: http://golight.com/products/registration.html, for
warranty protection.
If the Golight® RadioRay® does fail to operate under warranted
specifications, Please call 1-308-278-3131 for a Return Goods
Authorization number. After receiving an RGA#, send the light
and remote controls postage paid, plus $9.95 for shipping and
handling to: Golight, Inc. • Service Department • 37146
Old Hwy 17 • Culbertson, NE 69024-8226. No C.O.D.’s
accepted. Only the above manufacturer is authorized to perform
warranty repair or replace product.
Any consequential damages to person or property are excluded
from this warranty. Some states do not allow the exclusion and
limitation of incidental or consequential damages, therefore
the above limitations or exclusions may not apply to you. This
warranty gives you specific legal rights and you may also have
other rights.
End of Useful Life
For information regarding the proper disposal/recycling of the
light contact Golight at 800.557.0098
Golight Inc
37146 Old Hwy 17
Culbertson, NE 69024
800.557.0098 | 308.278.3131
www.golight.com | [email protected]
MODEL NUMBERS: 2000, 2051, 20004, 20514,
2007, 20074, 2057, 20574
Instruction Guide
Congratulations
You are now the owner of one of the finest remote control
searchlights available today. Thank you for letting Golight®
assist you in your lighting application needs. We’re proud
of our products and the technology that we’ve developed to
ensure our customers the most durable, versatile and power-
ful searchlights in the lighting industry.
Please read these instructions before using your new
Golight® Radioray®.

The Golight® RadioRay® Model 2000/2051, 20004/20514,
2007/2057 & 20074/20574 are designed to be permanently
attached to a vehicle. The 2-Speed Searchlight with
Directional Flexibility is controlled by a wireless remote, which
gives the operator a full 370° horizontal rotation and a 135°
vertical tilt with fingertip control.
The RadioRay® provides superior light penetration with Cr5
PentaBeam™ technology in a halogen configuration or with
state of the art P-Vex™ lens and LED technology.
The RadioRay® Includes:
• RadioRay® Searchlight
• Wireless Remote Control
• Wireless Dash Remote Control (2007, 2057, 20074, 20574)
• 2 A23 12V Batteries
• Permanent Mounting Gasket
• Rockguard (not Available with LED units)
MOUNTING INSTRUCTIONS
Determine the location for the light on your vehicle or boat.
The small arrow on the base indicates the normal forward
direction of the light. The light will rotate to the left of this
arrow approximately 185 and to the right approximately 185.
The beam will angle down about 45 and angles up to 90. The
location should take into consideration this beam movement to
ensure optimum usability.
Once the position and orientation are decided upon—use the
black rubber gasket as a footprint to mark the mounting of base
to vehicle. Drill 1/4 inch hole though mounting surface in the
middle of the footprint for passage of the power cord. Use
silicone sealant to fill opening around power cord.
IMPORTANT: Allow 3” of cord to remain under the light to
ensure full 370 rotation.
You should choose screw or bolt fasteners appropriate to the
surface to which you intend to attach the light. If you intend
to use the four small plastic caps provided to cover the screw
heads once installed, a #8 round head is recommended.
The black gasket should be installed on the lamp base prior to
attachment to the vehicle surface. NOTE: The small drain hole
in the edge of the gasket should normally face opposite the
forward direction of the vehicle—opposite the arrow molded in
the front of the base. Silicone or other like sealants should not
be used around the base gasket as it will limit the light’s ability
to drain excess water properly.
The 12 Volt DC power wire should be joined to the leads under
the lamp with appropriate automotive wire attachments. It is
critical that polarity be observed. Connect vehicle positive (+) to
spotlight positive (+) wire. Connect vehicle ground (-) to spotlight
ground (-) wire. Power should be fused at 10 Amps and be on
a dedicated circuit, or wired to an appropriate automotive relay
system.
PROGRAMMABLE REMOTE INSTRUCTIONS
The Golight® RadioRay® is controlled with a programmable
remote with 2187 different channels. This feature allows you
the freedom to change the channel selection, and the receiver
relearns the new selection.
PROGRAMMING THE TRANSMITTER.
This light has been pre-programmed at the factory, it is not
necessary to re-program the transmitter, but it is recommended.
1. IMPORTANT: Disconnect power.
2. Remove battery cover from remote control.
3. Set the 7 dip switches to a selection of your choice. There
are 3 positions on each; positive, negative and neutral. Use
a small screwdriver and select a position for each dip switch.
*Please note that the orientation of the +/– switch positions
may vary among different models of wireless remote controls.
4. Insert both A23 12V batteries with the +/– in the same
direction. Be sure batteries have adequate charge.
5. Replace battery cover.
a. Depress the on/off button and hold it down. Red
LED will light.
b. While holding the on/off button down, reinstall the
power (replace fuse or connect vehicle battery).
c. Keep on/off button depressed for 5-6 seconds, and
then release. The light should now be programmed.
WIRELESS DASH CONTROL
If you have a wireless dash control, please note that it is vital
for this to be attached to a flat / smooth surface with the 4
mounting screws included. The arrow under the rubber cover
should point up.
OPERATION OF GOLIGHT® RADIORAY®
1. Using the remote control, turn on the light by depressing the
on/off button.
2. With the 4-way arrows on the remote control, rotate your
light to the desired location. Depending upon conditions,
the wireless remote may be used up to 80 feet from the
RadioRay®.
3. The speed of the light rotation can be controlled by de-
pressing the tortoise/hare button one time and by depress-
ing it again to restore the original speed.
4. The spotlight should not be turned on when the snap on
lens cover (rockguard) is attached. (Not applicapble for
LED)
BATTERY INSTALLATION AND DISPOSAL
• Remove Battery Cover: remove the phillips head screw
securing the battery cover then remove the cover. With the
battery compartment now exposed, insert batteries accord-
ing to correct polarity. Remove the batteries by gripping
the
positive end of each battery and lifting.
For information regarding the proper disposal/recycling of the
batteries contact Golight at 800.557.0098
Use only 12v-A23 batteries in the Golight remote control
USAGE:
» This light is intended for off-road and utility use only
» This light is intended to be mounted outside the vehicle
while in use
» This light may only be disassembled and repaired by an
authorized representative
MISUSE:
» This light is not approved for road or highway use
» This light is not approved for underwater use
» This light is not approved for inverted mounting
» This light is not approved for use inside a vehicle or enclo-
sure and power should be disconnected prior to placing the
light in such circumstance
» This light may be damaged if operated in icing conditions
» This light may only be dismantled by an authorized Golight
representative
» Any violation of the above referenced misuses will
be considered grounds for warranty refusal