
2. Plug your Golight®into your vehicle's cigarette lighter outlet or
12 Volt direct battery hookup.
3. Using the remote control,turn on the light by depressing the
on/off button.
4. With the 4-way arrows on the remote control,rotate your light
to the desired location.
5. Unplug and remove light from vehicle. Store the light in optional
carrying case when not in use to extend the life of your Golight®.
6. The spotlight should not be turned on when the snap on lens
cover (rockguard) is attached.
WARNING: Unplug unit when not in use.
BULB REPLACEMENT
The Golight®utilizes a Philips®H-9 bulb, which may be purchased
through Golight, Inc. —308.278.3131 or 800.557.0098.
✱ This light is for off road and utility use only. It is not designed for
road use as a driving light.
For safe and efficient operation of your Golight®, observe these
guidelines:
•Using your Golight®in icing conditions could damage the
gear motors.
•Water can be removed from inside the light by peeling the
rubber suction cup from the base and then replacing it securely.
•It is important to keep the suction cup clean and free from
damage.
The Golight®is a Portable Searchlight designed to be permanently or
temporarily attached to a vehicle for your specific use. The Searchlight
with Directional Flexibility is controlled by a wired remote,which gives
the operator a full 370°horizontal rotation and a 135°vertical tilt with
fingertip control. The Golight®provides superior light penetration
with Cr5 PentaBeam™technology.
The Golight®Includes:
•Golight®Searchlight
(Free-standing light with suction mounting.)
•Wired Remote Control (Must be kept clean and dry.)
•Permanent Mounting Shoe
(Press spring lock to release and remove light.)
•Permanent Mounting Gasket
•Rockguard
•An Optional Magnetic Shoe (See Accessory Sheet)
MOUNTING INSTRUCTIONS —TEMPORARY:
1. Always clean mounting surface with a clean cloth.
2. Remove light from permanent mount shoe by depressing spring
loaded lock and sliding light out.
3. Place suction base on clean, dry surface and move side lever into
the locked position.
WARNING: Suction mount is for temporary use only. Check the
suction cup frequently to ensure that suction strength is maintained.
Temperature variations, rough terrain, grease and dirt affect the length
of time that the suction cup will remain in place.
MOUNTING INSTRUCTIONS —PERMANENT:
1. On clean, dry surface,place gasket and shoe in desired location.
Using 3/16" screws,attach shoe to vehicle.
2. Slip the Golight®into the shoe. Verify that the spring lock
secures the Golight®into the shoe. An optional magnetic
mounting shoe is available (see accessory sheet).
OPERATION OF GOLIGHT®
1. Place your Golight®into the mounting shoe or attach to the
outside of your vehicle (see mounting instructions).
IMPORTANT SAFETY INFORMATION
✱ This symbol is to alert you to important operating or servicing
instructions that appear in your instructions. Always follow basic
safety precautions when using this product to reduce the risk of
injury, fire or electric shock.
www.magnalight.com
1-800-369-6671
903-498-3363