Golight RADIORAY 2000 Manual

Congratulations
You are now the owner of one of the finest
remote control searchlights available today.
Thank you for letting Golight® assist you in your
lighting application needs. We're proud
of our products and the technology that
we've developed to ensure our customers
the most durable,versatile and powerful
searchlights in the lighting industry.
Please read these instructions before using your
new Golight®
Radioray®.
Three Year Limited Warranty
Golight, Inc. warrants the RadioRay®against any deemed defects
that are due to workmanship for parts or faulty materials, except
lamps, for three years from the date of the original purchase.
This warranty to the RadioRay®does not cover damage resulting
from unreasonable use or misuse, unreasonable maintenance or
loss,or labor costs.
Mounting the light upside down will void the warranty.
Warranty cards must be filled out and sent in within 30 days of
purchase to Golight, Inc. •RT 3 Box 37B •Culbertson, NE 69024,
for warranty protection. Register online at www.golight.com.
If the Golight®RadioRay®does fail to operate under warranted
specifications, send the light and remote controls postage paid,
plus $9.95 for shipping and handling to: Golight, Inc. •Service
Department •RT 3 Box 37B •Culbertson, NE 69024. No C.O.D.'s
accepted. Only the above manufacturer is authorized to perform
warranty repair or replace product.
Any consequential damages to person or property are excluded
from this warranty. Some states do not allow the exclusion and
limitation of incidental or consequential damages, therefore the
above limitations or exclusions may not apply to you. This
warranty gives you specific legal rights and you may also have
other rights.
Golight, Inc.
RT 3 Box 37B • Culbertson, NE 69024
800.557.0098 • 308.278.3131
[email protected]om • www.golight.com
For safe and efficient operation of your Golight®RadioRay®, observe
these guidelines:
Using your RadioRay®in icing conditions could damage the gear
motors. (Optional dome available - see accessory sheet.)
Always keep the remote in the raincoat provided. The remote must
be kept clean and dry to avoid damage to the internal circuitry.
Your Golight®RadioRay®is a radio transmitter and receiver operating
at 433MHz. Whenever the light is on, the internally mounted antenna
sends out and receives radio frequency (RF) energy.
•Modern electronic equipment, i.e. Personal medical devices such
as pacemakers,hearing aids, etc., are shielded from RF energy.
However,RF energy may affect some electronic equipment.
•Vehicle electronic systems may be affected by RF energy.
Check with your vehicle manufacturer representative to be sure
that your RadioRay®will not affect the electronic system of your
vehicle.
U.S. Patent 5,673,989
RADIORAY®
MODEL 2000/2051

the base.
The 12 Volt DC power wire should be joined to the leads under the
lamp with appropriate automotive wire attachments. It is critical that
polarity be observed. The (+) lead of the RadioRay®is marked with a
red tag. The power should be fused at 10 Amps and be on an ignition
switched circuit if possible.
PROGRAMMABLE REMOTE INSTRUCTIONS
The Golight®RadioRay®is controlled with a programmable remote
with 6561 different channels. This feature allows you the freedom to
change the channel selection, and the receiver relearns the new
selection.
PROGRAMMING THE TRANSMITTER.
This light has been pre-programmed at the factory, and it is not
necessary to re-program the transmitter, unless you experience
outside interference.
1. IMPORTANT: Disconnect power by removing fuse or
disconnecting vehicle battery.
2. Remove battery cover from remote control.
3. Set the 7 dip switches to a selection of your choice. There are 3
positions on each; positive,negative and neutral. Use a small
screwdriver and select a position for each dip switch. *Please note
that the orientation of the +/–switch positions may vary among
different models of wireless remote controls.
4. Insert both MN21 Duracell batteries with the +/–in the same
direction. Be sure batteries have adequate charge.
5. Replace battery cover.
a. Depress the on/off button and hold it down. Red LED will light.
b. While holding the on/off button down,reinstall the power
(replace fuse or connect vehicle battery).
c. Keep your finger on the on/off button for 5-6 seconds,and then
release. The light should now be programmed.
The Golight®RadioRay®Model 2000/2051 is designed to be
permanently attached to a vehicle. The 2-Speed Searchlight with
Directional Flexibility is controlled by a wireless remote,which gives
the operator a full 370°horizontal rotation and a 135°vertical tilt with
fingertip control. The RadioRay®provides superior light penetration
with Cr5 PentaBeam™technology.
The RadioRay®Includes:
•RadioRay®Searchlight
•Wireless Remote Control (must be kept clean and dry)
•2 Duracell MN21 Batteries
•Raincoat for Remote
•Permanent Mounting Gasket
•Mounting Screws and Caps
MOUNTING INSTRUCTIONS
Determine the location for the light on your vehicle or boat. The small
arrow on the base indicates the normal forward direction of the light.
The light will rotate to the left of this arrow approximately 190°and to
the right approximately 190°. The beam will angle down about 45°
and angles up to 90°, a full vertical. The location should take into
consideration this beam movement to ensure optimum usability.
Once the position and orientation are decided upon—use the black
rubber gasket as a footprint to mark the mounting of base to vehicle.
Drill 1/4 inch hole though mounting surface in the middle of the
footprint for passage of the power cord. Use silicone sealant to fill
opening around power cord. IMPORTANT: Allow 3" of cord to remain
under the light to ensure full 370°rotation.
You should choose screw or bolt fasteners appropriate to the surface
to which you intend to attach the light. If you intend to use the four
small plastic caps provided to cover the screw heads once installed, a
#8 round head is recommended.
The black gasket should be installed on the lamp base prior to
attachment to the vehicle surface. NOTE: The small drain hole in the
edge of the gasket should normally face opposite the forward
direction of the vehicle—opposite the arrow molded in the front of
OPERATION OF GOLIGHT®RADIORAY®
1. Using the remote control,turn on the light by depressing the
on/off button.
2. With the 4-way arrows on the remote control,rotate your light
to the desired location. Depending upon conditions,the
wireless remote may be used up to 100 feet from the RadioRay®.
3. The speed of the light rotation can be controlled by depressing
the +/–button one time and by depressing it again to
restore the original speed.
4. The spotlight should not be turned on when the snap on lens
cover (rockguard) is attached.
BULB REPLACEMENT
The Golight®RadioRay®utilizes a Philips®H-9 bulb,which may be
purchased through Golight,Inc. —308.278.3131 or 800.557.0098.
✱ This light is for off road and utility use only. It is not designed for
road use as a driving light.
✱ The RadioRay®complies with Part. 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This light and remote
may not cause harmful interference,and (2) this light and remote must
accept any interference received,including interference that may
cause undesired operation.
✱ FCC RULE Part. 15.21 - Changes or modifications made by the
user not expressly approved by Golight, Inc. for compliance could void
the user’s authority to operate the equipment.
IMPORTANT SAFETY INFORMATION
✱ This symbol is to alert you to important operating or servicing
instructions that appear in your instructions. Always follow basic
safety precautions when using this product to reduce the risk of
injury, fire or electric shock.