Goodmans GMR1886DAB User manual

Technical Specification
Model Number GMR1886DAB
Power Supply 230V AC ~ 50 Hz
4 x AA Batteries
DAB Specications RF section: Band III, 174 MHz to 240
MHz
Input 50R, nominal
GMR1886DAB
2. Connect power cable to DAB Radio and mains supply,
or insert 4 x AA batteries into the battery compartment.
Switch on.
4. The DAB radio will automatically scan for stations.
Troubleshooting
Problem What to do
There is no sound
from my radio
Check that the volume is not set to
minimum.
The display shows
‘NO SERVICES
AVAILABLE’ in DAB
mode
Make sure that DAB coverage exists in
your area.
Try adjusting the position of the aerial or
location of the radio.
Poor reception As with any radio service, there will be
areas of weak signal that cause poor
reception. Carry out a manual tune and
adjust the aerial while monitoring the
signal strength until the optimum signal
is obtained. If reception is still poor, try
re-locating the radio to another part of
the room.
The display has
gone blank or says
‘SERVICE OFF AIR’
This may occur if a broadcaster changes
the label of a service or removes a label
whilst you are listening to the station.
The radio will try to re-tune to the
station. Alternatively perform a scan.
I hear distortion on
some stations
This is due to a weak signal. Try re-
positioning the aerial to gain maximum
signal strength.
If the trouble persists, consult your
dealer or contact the Customer Helpline.
1. Raise and extend the aerial
3. When switching on for the rst time
www.goodmans.co.uk
Helpline: 08444 122 541

1
Power
• On/off switch.
• When using batteries to power the DAB
Radio:
Scanning for DAB Stations
• Scan for available stations.
4
Changing DAB stations
5
Presets
Create a list of your 10 favourite DAB and FM stations:
Store
Select
3
Volume
Manual Tuning
• Manually tune to a specic channel/frequency and add to station list.
• Tune to the desired station.
9
Using FM Radio
• Switch between DAB or FM Radio
• To tune (scanning stops when a station is found):
• To resume scanning:
Menu
• Change the options on your DAB Radio. Press to select an option when in the
menu below:
Starts a full scan
Manually tune to a specic
channel/frequency.
Dynamic Range Control, alters
the degree of compression.
Removes a station from the
stored list. Accesses the System menu.
7
System menu
• Alter system options. Press to select an option when in the menu below:
Countdown timer until
radio switches off.
Time for backlight
switches off.
Language used in menu
options.
Deletes all settings and
reverts to factory settings.
Displays the current
software version.
2
Power
Volume
Select
Channel
Preset
Info/Menu
DAB/FM
6
8