
Gorenje reserves the absolute and unrestricted right to change product materials and specifications, at any time, without notice. Warranties: Please see the Use & Care manual or Gorenje Canada website for a statement of limited warranty.
For more information on our entire line of products, go to gorenjecanada.ca or call 905.829.3980 © Gorenje. All rights reserved. 2
TECHNICAL SPECIFICATIONS
Noise Level Drying 64 dB(A)re 1 pW
Electrical Connection 208/230 V / 15 Amp / 60Hz
Connected Load 2,+00 W
Consumption in Standby Mode 0.5 W
DIMENSIONS & WEIGHT
Unit (WxHxD) inch 235/8” x 337/16” x 245/8”
Unit (WxHxD) mm 600 mm x 850 mm x 625 mm
Net Weight (KG) 34 KG
Gross Weight (KG) 38.4 KG
ENVIRONMENTAL STANDARDS
ENERGYSTAR®l
• The dryer has two humid air exhaust openings on the front and rear
side (options a/b). Close one of them with a cap and connect the air
exhaust duct to the other one.
• The distance between the dryer and the air evacuation opening
(ventilation opening, window) may not exceed 2 meters. Otherwise,
moisture could accumulate in the air exhaust duct.
• Do not evacuate the air from the dryer through channels used for
appliances or devices that use natural gas or other fuels for their
operation.
• The dryer may not be in contact with a wall or adjacent furniture. For
optimum dryer operation, we recommend observing the clearance
from the walls as indicated in the figure. In case of failure to heed the
required minimum clearance, the dryer may overheat.
• Vents on the appliance back wall, and humid air exhaust opening on
the side or back wall may not be obstructed.
• Place the appliance in a thoroughly ventilated room with a window or
ventilation fan.
• Connect the exhaust duct to the air exhaust opening. Do not connect
the exhaust to a duct that is also used for evacuation of combustion
gases from other appliances or gases from appliances that use other
combustible substances for their operation.
• The dryer emits heat. Therefore, do not place it in a very small room, as
the drying process may take longer due to limited amount of available
air.
• Lighting in the room should be sucient to allow reading the
information on the display unit on the control panel.
DP7C
SPECIFICATIONS
SELECTING THE ROOM
EVACUATION OF HUMID AIR